Full Product Manual

ManualsBrandsDelta ManualsDust Collectors1 Micron Filter Canister

50-766 Dust Canister

Part No. DPEC004410 Dated: 03-21-2017

50-766 DUST CANISTER

(FITS 50-767 T2 DUST COLLECTOR)

Delta Power Equipment Corporation • 2651 New Cut Road, Spartanburg, SC 29303 • 1-800-223-7278

IF YOU HAVE ANY QUESTIONS OR COMMENTS

ABOUT THIS OR ANY DELTA® POWER EQUIPMENT

CORPORATION ACCESSORY, CALL US TOLL FREE

AT 1-800-223-7278.

To reduce the risk of injury, read the

tool instruction manual before using

any accessory. Failure to heed these warnings may

result in personal injury and serious damage to the

tool and the accessory. When servicing this tool, use

only identical replacement parts.

To reduce the risk of injury, turn unit

off and disconnect it from power

source before installing and removing accessories,

before adjusting or when making repairs. An

accidental start-up can cause injury.

Always wear certied safety

equipment: ANSI Z87.1 eye protection

(CAN/CSA Z94.3) with side shields.

After unpacking carton check for parts contents illustrated

in Figure1. (Service Part No.)

Place the handle crank (D) on top of the canister lter (A).

Be sure to align the handle crank (D) and M6 x 16 hex

bolt (E) with the at surface on the canister rod, located

on top of canister (A). Tighten securely with a 10mm

wrench. Peel the backing off air seal gasket (C) and

press the gasket onto the outside of the dust collector

blower housing, as shown in Figure 2. Gently place the

assembled canister lter onto the dust collector blower

housing, as shown in Figure 3, and use the belt clamp

(B) to tighten.

Be sure canister is fully seated down on

the dust collector drum and that the belt

clamp is tightened securely to prevent canister from

tipping over.

Dust canister is shown fully assembled to a dust collector

in Figure 4 and 4a.

A. Canister Filter

B. Belt Clamp (DPEC004473)

C. Air Seal Gasket (DPEC004474)

D. Handle Crank (DPEC004472)

E. M6 x 16 Hex Bolt

SAFETY INSTRUCTIONS

UNPACKING CONTENT

ASSEMBLY

FIGURE 1

FIGURE 2

FIGURE 3

Summary of content (2 pages)

PAGE 1
50-766 Dust Canister Part No. DPEC004410 Dated: 03-21-2017 50-766 DUST CANISTER (FITS 50-767 T2 DUST COLLECTOR) IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DELTA® POWER EQUIPMENT CORPORATION ACCESSORY, CALL US TOLL FREE AT 1-800-223-7278. B SAFETY INSTRUCTIONS C To reduce the risk of injury, read the tool instruction manual before using any accessory. Failure to heed these warnings may result in personal injury and serious damage to the tool and the accessory.
PAGE 2
OPERATION a As needed, rotate handle around the canister to clean the filter and allow better airflow. FIGURE 4 50-766 RÉSERVOIR DE POUSSIÈRE DEPÓSITO PARA POLVO 50-766 (S’INSTALLE SUR LE DÉPOUSSIÉREUR 50-767 T2) (SE ADAPTA AL COLECTOR DE POLVO 50-767 T2) SI VOUS AVEZ DES QUESTIONS OU COMMENTAIRES SUR CET ACCESSOIRE OU TOUT AUTRE ACCESSOIRE DE DELTA® POWER EQUIPMENT CORPORATION, APPELEZ-NOUS SANS FRAIS AU 1-800-223-7278.