Installation Guide

INSTALLATION & ASSEMBLY INSTRUCTIONS
2786/2789 TOWEL SHELF WITH 2 BARS
Part I
Installation of Towel Shelf item onto Wall
1. Installation of Wall Flanges (A & B) on Walls
with Wood Studs or Backing.
(a) Position one of the wall flanges (A)
vertically on the wall at the desired
height. using a level (to make sure
that the wall flange is straight). Mark
hole locations with nail or punch in
centers of projecting fittings (C).
(see figure 1)
(b) Position the other wall flange (B)
vertically on the wall (see figure 1 for your
center to center distance from wall flange A).
Use a level to make sure that the wall flange
is straight and that both wall flanges align
horizontally with each other. Mark hole
locations with nail or punch in centers of
projecting fittings (C).
(see figure 1)
(c) After hole locations are marked, remove
wall flanges and drill 5/32" holes into
studs or backing.
(d) Mount wall flanges with #10 x 1 1/2" screws
provided. Make sure that set screw holes
on the projecting fittings (c) are facing down.
2. Installation of Wall Flanges (A & B) on Drywall.
(a) Same as #1 (a,b).
(b) After hole location are marked, remove
wall flanges and drill1/2" holes.
(c) Mount with 3/16" x 3" toggle bolts
provided. Make sure that set screw holes
on the projecting fittings (c) are facing down.
Part II
Assembly of Towel Shelf and 2 Bars onto Wall Flanges
IMPORTANT: Shelf and bars must be mounted on fittings
in specified order below.
1. Mount towel shelf (D) by sliding open ends of tubing
onto the top 2 projecting fittings (c) on wall flanges
(A and B). Secure towel shelf by inserting set
screws (E) through the holes in the underside of
the towel shelf near the wall flange and fasten
set screws until the screw heads are flush.
(see figure 2)
2. Mount medium size towel bar (F) below towel shelf
in the same way as in stop number 1.
(see figure 2)
3. Mount the small size towel bar (G) below medium
towel bar onto the bottom 2 fitting of flange A & B,
same way as in stop number 1.
IMPORTANT:
To prolong the life of this product, clean regularly with
a soft damp cloth. Do Not Use detergents or cleansers
as they may be harmful to finish.
REQUIRED TOOLS:
24" General Purpose Level. Standard size phillips head screwdriver
Standard size slotted screwdriver required for installation of toggle bolts in drywall.
Liberty Hardware® Manufacturing Corporation
140 Business Park Drive Winston-Salem, NC 27107
www.libertyhardware.com
@2007 LHMC, A Masco Company
Made in - Fabriqué en - Hecho en China
CP2389-XXX
Figure 1
Figure 2
A
A
C
C
B
B
D
F
G
C
C
Center to Center Mounting Distances
Model 2786
18" (45.75cm)
Model 2789
24" (61cm)
E
E E E