Operating Guide

ManualsBrandsDelta ManualsOne-Piece Showers213637AC00

Para instalar fácilmente su unidad

para ducha Delta necesitará lo

• LEER TODAS las instrucciones

completamente antes de empezar.

• LEER TODOS los avisos, cuidados,

e nformación de mantenimiento.

• Comprar las conexiones correctas para el

suministro de agua.

For easy installation of your

Delta shower unit you will need to:

• READ ALL the instructions completely

before beginning.

• READ ALL warnings, care, and

maintenance information.

• Purchase the correct water supply

components.

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

Pour une installation facile de votre

cabine de douche Delta, vous

devrez :

• LIRE TOUTES les instructions avant

de débuter;

• LIRE TOUS les avertissements ainsi que

toutes les instructions de nettoyage et d’en-

tretien;

• Acheter le bon nécessaire

de raccordement.

9/17/18 Rev. B

Acrylic with Innovex™ Technology Shower Unit

Unidad para ducha de acrílico con tecnología

Innovex™

Cabine de douche acrylique avec technologie

Innovex

Consult your local plumbing codes prior to installation.

Consulte los códigos/normas locales de plomería antes de

realizar la instalación.

Consultez les codes de plomberie de votre région avant

l’installation.

*Some installations may require two pieces of cardboard

*Algunas instalaciones pueden requerir el uso de dos pedazos de cartón.

*Certaines installations peuvent nécessiter deux morceaux de carton.

1/8” Drill Bit

Broca de taladro de

3,2 mm (1/8”)

Foret de 1/8 po

Phillips Screw Bit

Broca de taladro Phillips

Embout Phillips

Sealant

Sellador

Produit d'étanchéité

Cardboard*

Cartón*

Carton*

#8 X 1” Wood Screws

Tornillos para madera n.º 8 x 2,5 cm (1in).

Vis à bois nº 8 x 1 po

92445

www.deltafaucet.com

Registre su sistema de baño en Deltafaucet.com

Inscrivez votre système de bains à Deltafaucet.com

You may need / Usted puede necesitar: /

Articles dont vous pouvez avoir besoin:

Summary of content (16 pages)

PAGE 1
92445 Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici. Register your bathing system at Deltafaucet.co Registre su sistema de baño en Deltafaucet.com Inscrivez votre système de bains à Deltafaucet.com For easy installation of your Delta shower unit you will need to: • READ ALL the instructions completely before beginning. • READ ALL warnings, care, and maintenance information. • Purchase the correct water supply components.
PAGE 2
Acrylic with Innovex™ Technology Shower Unit Limited Warranty All parts and finishes of the Delta® acrylic with Innovex™ Technology shower unit are warranted to the original consumer purchaser to be free from defects in material and workmanship for the time periods listed below. Delta recommends using a professional plumber for all installation and repair.
PAGE 3
Before You Start IMPORTANT: Shower units are designed to be installed in new and/or existing construction. For the best protection of the unit, it is recommended that the unit not be removed from the packaging until ready for installation. • Check drai n lengths as some drain products require a drain and waste assembly extension. • When disa ssembling unit, save hardware and take care not to damage edges of unit. • See framing details in section b efore starting.
PAGE 4
DRAIN AND STUD PLACEMENT COLOCACIÓN DEL DRENAJE Y LOS MONTANTES EMPLACEMENT DU RENVOI ET DES MONTANTS 1 Install two horizontal 2 x 4’s (1) between back wall studs as shown. Secure 2 x 4’s to studs using 2-1/2” screws. Ensure that the face of the horizontal 2 x 4 is flush with the surface of the vertical studs. Instale 2 horizontales de 2 x 4 (1) entre los montantes de pared traseros como se muestra. Fije las maderas 2 x 4 a los montantes usando tornillos para muro en seco de 2-1/2”.
PAGE 5
1 B. A. C. De pth 1 1 He 2 igh t dth Wi A. Check unit dimensions in specific areas as shown. Verify that framing dimensions will accomodate product. Consult specifications on pages 12-14 for your specific unit to ensure site requirements are met - if you do not have specifications for your unit, they can be found at www.deltafaucet.com/ bathingsystems. B. Clean debris from area and check for square and level of framing (including floor). C.
PAGE 6
2 C. B. A. IF THE SUBFLOOR IS NOT FLAT AND LEVEL SI L A SUPERFICIE DE L INS TALACIÓN NO ESTÁ NIVELADA SI LE FAUX-PLANCHER N’EST PAS PL AT ET DE NIVEAU A. IF THE SUBFLOOR IS NOT FLAT AND LEVEL, it is recommended to put down a mortar bed where the base will be psitioned. B. Clear any debris from opening before sliding in unit. C. Insert cardboard or other material to protect surface. Do not remove until all work has ceased in room. B.
PAGE 7
3 C. B. A. Size of Shim Tamaño de la cuña Dimensions des cales Back View Vista posterior Vue arrière shim cuña cales A. Mark unit position on all sides of framing before unit is leveled. B. Check level left to right and front to back. CAUTION: Shower floor and dam has a slope and should not be used for leveling. C. Mark drain location on floor. C. Marque el área de desagüe en el piso. C. Marquez la position du drain sur le plancher. NOTE: Mark framing again after leveling.
PAGE 8
4 B. A. C. X X Y Y A. Pull unit out of framing. B. Measure plumbing fixture locations. C. Measure and mark plumbing fixture locations on desired wall. CAUTION: Drill chuck can damage panel. Drill holes from back side of wall. Using proper size hole saw, cut out plumbing fixture holes. A. Retire la unidad del marco. B. Mida la ubicación de los conectores de fontanería. C. Mida y marque la ubicación de los conectores de fontanería en la pared deseada.
PAGE 9
5 C. B. 1 A. 1 2 6” A 2 B 6” 3 A. A. A. Remove backing from self-adhesive pad. Center pad over mixing valve hole and press firmly onto back side of panel. Using a utility knife, trim pad to reveal mixing valve hole. B. Quite la cobertura de la almohadilla autoadhesiva. Coloque la almohadilla en el centro sobre el agujero de la válvula de mezclado y presione firmemente hacia la parte trasera del panel.
PAGE 10
6 B. A. A. Clear any debris and slide unit back into framing. B. C. Pre-drill unit with 1/8” drill bit approximately every 8” vertically and on every stud location along the top flange using dimples as guides. DO NOT drill into studs at this time. C. Insert shims to fill any gaps. This will prevent warping and breakage. C. Introduzca las cuñas para cubrir cualquier espacio abierto. Esto ayudará a evitar daños y pandeamiento. C. Insérez des cales pour remplir les espaces vides.
PAGE 11
7 A. C. B. 1 2 A. Use #8 x 1” wood screws to install this product. B. Score shims and remove excess shim material around flange. C. CAUTION: Take care not to blemish the unit with drill chuck or hammer. Apply sealant over screws and around openings for the plumbing fixtures. Complete installation of drain and waste assembly (not included). Follow manufacturer’s waste assembly installation instructions. NOTE: Over-tightening may crack the unit.
PAGE 12
Specifications for 213232AC00 32” x 32” 15/16” BACK WALL - FIRST DIMPLE PARED POSTERIOR - PRIMERA INDENTACIÓN MUR ARRIÈRE - PREMIER CREUX SHELF ESTANTE ÉTAGÈRE Especificaciones de 213232AC00 32” x 32” (81 cm x 81 cm) 1-1/16” WALL - FIRST NAIL GUIDE 1-1/16” DE LA PARED – PRIMERA GUÍA DE CLAVOS MUR 1-1/16 PO – PREMIER GUIDE APPROX. APROX. APPROX. 1-1/16” NAIL GUIDE SPACING (TYP.) SEPARACIÓN DE LA GUÍA DE CLAVOS (TÍPICA) ESPACEMENT DES GUIDES DE CLOUS (TYP.
PAGE 13
Specifications for 213637AC00 36” x 37” 1-5/8” BACK WALL - FIRST DIMPLE PARED POSTERIOR - PRIMERA INDENTACIÓN MUR ARRIÈRE - PREMIER CREUX Especificaciones de 213637AC00 36” x 37” (91 cm x 94 cm) SHELF ESTANTE ÉTAGÈRE 1” WALL - FIRST NAIL GUIDE 1” DE LA PARED – PRIMERA GUÍA DE CLAVOS MUR 1 PO – PREMIER GUIDE APPROX. APROX. APPROX. Caractéristiques techniques pour les modèles 213637AC00 91,4 cm x 93,9 cm (36 po x 37 po) 1-1/16” NAIL GUIDE SPACING (TYP.
PAGE 14
1-3/4” BACK WALL - FIRST NAIL GUIDE 1-3/4” POSTERIOR DE LA PARED – PRIMERA GUÍA DE CLAVOS DE MUR ARRIÈRE 1-3/4 PO – PREMIER GUIDE Specifications for 214836AC00 48” x 36” SHELF ESTANTE ÉTAGÈRE Especificaciones de 214836AC00 48” x 36” (122 cm x 91 cm) 1-11/16” WALL - FIRST NAIL GUIDE 1” DE LA PARED – PRIMERA GUÍA DE CLAVOS MUR 1 PO – PREMIER GUIDE APPROX. APROX. APPROX. 1-1/16” NAIL GUIDE SPACING (TYP.) SEPARACIÓN DE LA GUÍA DE CLAVOS (TÍPICA) ESPACEMENT DES GUIDES DE CLOUS (TYP.
PAGE 15
Notes/Notas/Notes 15 92445 Rev.
PAGE 16
Notes/Notas/Notes 16 92445 Rev.