Installation Guide

ManualsBrandsDelta ManualsKitchenDeLuca Single-Handle Pull-Down Sprayer Kitchen Faucet with ShieldSpray Technology and Soap Dispenser in Matte Black

07/11/2017 Rev. Cwww.deltafaucet.com

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need/Usted puede necesitar/

Articles dont vous pouvez avoir besoin:

Para instalación fácil de su llave Delta

usted necesitará:

• LEER TODAS las instrucciones completamente antes

de empezar.

• LEER TODOS los avisos, cuidados, e información de

mantenimiento.

For easy installation of your Delta

faucet you will need:

• To READ ALL the instructions completely before

beginning.

• To READ ALL warnings, care, and maintenance

information.

Pour installer votre robinet Delta

facilement, vous devez:

• LIRE TOUTES les instructions avant de débuter;

• LIRE TOUS les avertissements ainsi que toutes les

instructions de nettoyage et d’entretien.

Models/Modelos/Modèles

19912-DST, 19932-DST,

19912Z-BLSD-DST &

19912Z-SSSD-DST

Series/Series/Seria

SILICONE

Icons

WARNING: THIS FAUCET IS NOT TO BE USED WITH

PORTABLE DISHWASHERS!

ADVERTENCIA: ¡SESTA LLAVE NO SE DEBE UTILIZAR

CON MAQUINAS LAVAPLATOS PORTATILES!

AVERTISSEMENT: ON NE DOIT PAS BRANCHER UN

LAVE-VAISSELE PORTATIF SUR CE ROBINET!

HIGH-RISE PULL-DOWN KITCHEN FAUCETS

LLAVES DE AGUA CUELLO DE GANSO, DESLIZABLES,

PARA COCINAS

ROBINET À COL DE CYGNE ET OU D’ÎLOT DE CUISINE

1/8"

80320

Backflow Protection System

Your Delta Faucet pull-out spout incorporates a backflow

protection system that has been tested to be in compliance

with ASME A112.18.3 and ASME A112.18.1 / CSA B125.1. It

incorporates two certified check valves in series, which operate

independently and are integral, non-serviceable parts of the

wand assembly.

Dispositif anti-siphonnage

Le bec rétractable de votre robinet Delta comporte un dispositif

anti-siphonnage qui a été éprouvé et qui est conforme aux

normes ASME A112.18.3 et ASME A112.18.1 / CSA B125.1.

Ce dispositif se compose de deux clapets indépendants

homologués, montés en série dans le tube rigide, qui sont non

réparables.

Sistema de protección contra el contraflujo

Su llave de agua tipo deslizable Delta tiene un sistema de protec-

ción contra el contraflujo, incorporado, que ha sido probado para

cumplir con los requisitos de ASME A112.18.3 y ASME A112.18.1

/ CSA B125.1. Este incorpora en la pieza de mano dos válvulas

de retención o checadoras certificadas en una serie, las cuales

operan independientemente y son piezas integrantes que no

requieren servicio.

Summary of content (12 pages)

PAGE 1
80320 HIGH-RISE PULL-DOWN KITCHEN FAUCETS LLAVES DE AGUA CUELLO DE GANSO, DESLIZABLES, PARA COCINAS ROBINET À COL DE CYGNE ET OU D’ÎLOT DE CUISINE Models/Modelos/Modèles 19912-DST, 19932-DST, 19912Z-BLSD-DST & 19912Z-SSSD-DST Series/Series/Seria Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici.
PAGE 2
1 A. A. 19932-DST B. 19912-DST 5 1 3 2 4 2 2 2 4 3 2 1 6 7 3 8 4 Model 19932-DST Model 19912-DST All Models Modelos 19932-DST Modelo 19912-DST Todos los Modelos Modèles 19932-DST Modèle 19912-DST Tous les Modèles A. Remove adhesive backing (1) from gasket (2). Apply the adhesive side of the gasket into groove in the underside of the faucet base (3). Insert faucet tubes and mounting shank (4) through mounting hole. A. Quite el forro adhesivo (1) de el empaque (2).
PAGE 3
Optional / Opcional / Facultative A. B. C. 6 1 66 3 5 5 2 7 3 8 7 1 9 4 Optional Escutcheon Installation A. For installations using the 10" escutcheon, be certain and use the escutcheon (1) and under cover plate (2). Place the shanks (3) of the escutcheon/under cover plate assembly into the mounting holes of the sink. B. Slide the tubes and shank (4) of the hub through the escutcheon and mounting holes, then install hub onto escutcheon (1).
PAGE 4
2 A. B. OR 2 1 O 2 OU 3 2 1 3 4 2 1 4 A. Water Line Connections Ensure all fittings and end connections are free of debris. Faucet fittings (1) are 3/8" compression, with ends colored red for hot and blue for cold. Loop tubing (2) if it is too long. Note: Recommended tubing minimum bend diameter is 8". Secure metal nut (3) on faucet tube to supply valve connection (4) and hand tighten, then tighten one additional turn with wrench. DO NOT OVERTIGHTEN. Repeat for other tube.
PAGE 5
Correct method Método Correcto Bonne méthode Incorrect Installation Instalación Incorrecta Installation Incorrecte 2 3 1 4 Custom Fit Connections - Plastic Sleeve Installation Instructions 1. Identify desired length of tube (1). Leave 1" - 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free. 2. Slide nut (2) and plastic sleeve (3) onto cut tube. Ensure sleeve is oriented as shown. 3. Insert tube into outlet fitting (4).
PAGE 6
3 C. B. A. 2 2 1 1 3 Flush Supply Lines B. Then, while holding the outlet tube (2) over the C. Move faucet handle (2) to the off position, and A. Coloque un cubo o balde debajo del accesorio de B. Luego, mientras que sostiene el tubo de salida (2) C. Mueva la manija de la llave (2) a la posición Rincez les tuyaux d’alimentation A. Placez un seau sous le raccord de sortie (1) et B. Ensuite, tenez le tube de sortie (2) au-dessus C. Déplacez la manette (2) en position d’arrêt, A.
PAGE 7
4 A. B. 5 2 6 3 4 2 3 1 4 1 1 5 Soap Dispenser Installation Note: Soap dispenser not included with all models. Hose Installation B. Side View A. Insert hose end (1) through hose weight assembly (2). Vista lateral B. Push hose end (1) onto faucet outlet (3). Attach clip (4) over hose and outlet as shown. Pull down moderately to ensure connection has been made.
PAGE 8
7 6 2 Optional Opcional Facultatif 3 3 Setting The Handle Limit Stop (Optional) 1 This faucet includes an integrated handle limit stop that has two positions. Position 1, to the left, allows full handle motion (the full range between “all cold” to “all hot”). The faucet is set in position 1 in the factory. Position 2, to the right, allows half of the normal handle motion (“all cold” to “mixed hot/cold”). The handle limit stop can be adjusted by the homeowner once the faucet is installed.
PAGE 9
Press Button Pulsar botón Pressez le bouton 4 5 3 6 7 1 2 Maintenance If faucet exhibits very low flow A. Remove and clean aerator (1) (Note: some models require wrench (2) to remove aerator.), or B. Unscrew hose from spray head and clean debris from screen (the screen is located just inside the spray (3). Note: Not all models have screens. IMPORTANT: Reinstall screen to the spray head. (Failure to reinstall the screen could damage internal parts.
PAGE 10
Model / Modelo / Modèle 19912-DST, 19912Z-BLSD-DST & 19912Z-SSSD-DST RP70712p Lever Handle, Set Screw & Button Manijas de Palanca, Tornillo de Presión y Botón Manette, Vis de calage et Bouton RP23093 Set Screw Tornillo de Presión Vis de calage RP62875 Retainer Detenedor Arrêtoir RP80977 Wand Retainer & Replacement Kit Soporte para el mango y piezas de repuesto Trousse de rechange et pièce de retenue de douchette RP90248 Aerator & Wrench Aereador y Llave Aérateur et Clé RP93640p Sprayer & Hose Assembly (
PAGE 11
Model / Modelo / Modèle 19932-DST RP70706p Lever Handle, Set Screw & Button Manijas de Palanca, Tornillo y Botón Manette, Vis et bouton RP47666p Set Screw Tornillo de Presión Vis de calage RP54234p Button Botón Bouton RP80977 Wand Retainer & Replacement Kit Soporte para el mango y piezas de repuesto Trousse de rechange et pièce de retenue de douchette RP62875 Retainer Detenedor Arrêtoir RP51502p Cap Casquete Embase RP51503 Bonnet Bonete Chapeau RP50587 Valve Assembly Ensamble de la válvula Soupape RP
PAGE 12
Limited Warranty on Delta® Faucets Parts and Finish All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed or, for commercial users, for 5 years from the date of purchase.