Installation Guide

ManualsBrandsDelta ManualsKitchen ApplianceSingle-Handle Pull-Down Kitchen Faucet with Soap Dispenser in Stainless Featuring MagnaTite Docking

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need

Usted puede necesitar

Articles dont vous pouvez avoir besoin:

Para instalación fácil de su llave Delta usted necesitará:

•LEER TODASlasinstruccionescompletamenteantesdeempezar.

•LEER TODOSlosavisos,cuidados,einformacióndemantenimiento.

For easy installation of your Delta faucet you will need:

•ToREAD ALLtheinstructionscompletelybeforebeginning.

•ToREAD ALLwarnings,care,andmaintenanceinformation.

Pour installer votre robinet Delta facilement, vous devez:

•LIRE TOUTESlesinstructionsavantdedébuter;

•LIRE TOUSlesavertissementsainsiquetouteslesinstructions

denettoyageetd’entretien.

Models/Modelos/Modèles

989-DST,999-DST,

4153-DST,16961-DST,

16968-DST&19950-DST

Series/Series/Seria

SILICONE

Icons

9/26/12   Rev.C

ASMEA112.18.1/CSAB125.1

ICC/ANSIA117.1

MEETSOREXCEEDS—ASMEA112.18.1/CSAB125.1

ALCANZAOEXCEDELASSIGIENTESNORMAS—ASMEA112.18.1/CSAB125.1

WARNING: thisfaucetisnottobeusedwithportabledishwashers!

ADVERTENCIA: ¡sestallavenosedebeutilizarconmaquinaslavaplatosportatiles!

AVERTISSEMENT: onnedoitpasbrancherunlave-vaisseleportatifsurcerobinet!

LEROBINETESTCONFORMEOUSUPÈRIEURAUXEXIGENCESDESNORMES

SUIVANTES:ASMEA112.18.1/CSAB125.1

HIGH-RISE PULL-DOWN KITCHEN AND

BAR / PREP FAUCETS

LLAVES DE AGUA CUELLO DE GANSO,

DESLIZABLES, PARA COCINAS Y BARES / PREP

ROBINET À COL DE CYGNE ET BEC-DOUCHETTE

POUR ÉVIER DE BAR OU D’ÎLOT DE CUISINE

1/8"

Backflow Protection System

YourDeltaFaucetpull-outspoutincorporatesabackflowprotection

systemthathasbeentestedtobeincompliancewithASMEA112.18.3

andASMEA112.18.1/CSAB125.1.Itincorporatestwocertifiedcheck

valvesinseries,whichoperateindependentlyandareintegral,

non-serviceablepartsofthewandassembly.

Sistema de protección contra el contraflujo

SullavedeaguatipodeslizableDeltatieneunsistemadeproteccióncon-

traelcontraflujo,incorporado,quehasidoprobadoparacumplirconlos

requisitosdeASMEA112.18.3yASMEA112.18.1/CSAB125.1.Este

incorporaenlapiezademanodosválvulasderetenciónochecadoras

certificadasenunaserie,lascualesoperanindependientementeyson

piezasintegrantesquenorequierenservicio.

Dispositif anti-siphonnage

LebecrétractabledevotrerobinetDeltacomporteundispositif

anti-siphonnagequiaétééprouvéetquiestconformeauxnormes

ASMEA112.18.3etASMEA112.18.1/CSAB125.1.Cedispositifse

composededeuxclapetsindépendantshomologués,montésensérie

dansletuberigide,quisontnonréparables.

63235

www.deltafaucet.com

Summary of content (16 pages)

PAGE 1
HIGH-RISE PULL-DOWN KITCHEN AND BAR / PREP FAUCETS LLAVES DE AGUA CUELLO DE GANSO, DESLIZABLES, PARA COCINAS Y BARES / PREP ROBINET À COL DE CYGNE ET BEC-DOUCHETTE POUR ÉVIER DE BAR OU D’ÎLOT DE CUISINE 63235 ASME A112.18.1 / CSA B125.1 ICC / ANSI A117.
PAGE 2
Limited Warranty on Delta® Faucets Parts and Finish All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed or, for commercial users, for 5 years from the date of purchase.
PAGE 3
4 5 6 3 7 1 2 1 Maintenance If faucet exhibits very low flow A. Remove and clean aerator (1) (Note: some models require wrench (2) to remove aerator.), or B. (989 Series Only) Unscrew hose from spray head and clean debris from screen (the screen is located just inside the spray (3)). IMPORTANT: Reinstall screen to the spray head. (Failure to reinstall the screen could damage internal parts.) If faucet leaks from under handle: Remove handle (4) and cap (5).
PAGE 4
Models / Modelos / Modèles 989-DST & 999-DST RP60923 Friction Spacers & Clip Aro para el Surtidor & Arandela de Fricción Anneau du bec & rondelle de frottement ▲ Specify Finish Especifíque el Acabado Précisez le fini RP32529▲ Aerator Aireador Aérateur RP53101▲ (model 999) Sprayer Assembly (includes aerator) Ensamble de rociador (incluye el aireador) Pulvérisateur (inclut aérateur) RP47270▲ Lever Handle Manijas de Palanca Manette RP47667 Aerator Aireador Aérateur RP51502▲ Cap C
PAGE 5
Models / Modelos / Modèles 4153-DST RP62776▲ Set Screw & Button Tornillo de Presión y Botón Vis de calage et bouton RP62774▲ Sout Assembly Ensamble del Tubo de Salida Bec RP62775▲ Lever Handle Manijas de Palanca Manette RP62773▲ Sprayer Assembly Ensamble de rociador Pulvérisateur ▲ Specify Finish Especifíque el Acabado Précisez le fini RP62777 Friction Spacers Arandela de Fricción Rondelle de frottement RP51503 Bonnet Bonete Chapeau RP50587 Valve Assembly Ensamble
PAGE 6
RP49300▲ Set Screw & Button Tornillo de Presión y Botón Vis de calage et bouton Models / Modelos / Modèles 16961-DST RP53438▲ Sprayer Assembly (includes aerator) Ensamble de rociador (incluye el aireador) Pulvérisateur (inclut aérateur) ▲ Specify Finish Especifíque el Acabado Précisez le fini RP54731▲ Lever Handle Manijas de Palanca Manette RP60923 Friction Spacers & Clip Aro para el Surtidor & Arandela de Fricción Anneau du bec & rondelle de frottement RP51503 Bonnet Bonete Cha
PAGE 7
Models / Modelos / Modèles 16968-DST RP60923 Friction Spacers & Clip Aro para el Surtidor & Arandela de Fricción Anneau du bec & rondelle de frottement RP52610▲ Trim Ring, Base and Gasket Aro de Accesorio, Base y Empaque Anneau de finition, Embase et Joint RP50788 Gasket Only Sólo el Empaque Joint seulement RP52609 Mounting Bracket & Nut Abrazadera y Tuerca Fixation et écrou RP47888 Pump Bomba Pompe RP49299▲ Lever Handle Manijas de Palanca Manette RP51502▲ Cap RP37490 Casquete Thin Deck Aid Embase Sos
PAGE 8
Model / Modelo / Modèle 19950-DST RP60934▲ Sprayer Assembly (includes aerator) Ensamble de rociador (incluye el aireador) Pulvérisateur (inclut aérateur) RP53879▲ Button Botón Bouton ▲ Specify Finish Especifíque el Acabado Précisez le fini RP54233 Set Screw Tornillo de Presión Vis de calage RP60937▲ Lever Handle Manijas de Palanca Manette RP51502▲ Cap Casquete Embase RP62875 Retainer Detenedor Arrêtoir RP51503 Bonnet Bonete Chapeau RP50815 Aerator & Wrench Aereador y Llave Aérateur et Clé RP3
PAGE 9
89-DST & 999-DST 1 16961-DST & 16968-DST 5 RP37490 (Not Included In All Models) RP37490 (Not Included In All Models) 3 6 1 3 7 2 4 4 3 32 8 2 1 9 1 4 All Models Models 16961-DST & 16968-DST Note: To improve stability on thin gage metal sinks, RP37490 thin deck aid (see illustration above) is available free of charge by calling 1-800345-3358. Place gasket (1) into groove on bottom of base ring (2). Place base ring onto sink over mounting hole, then install trim ring (3) over base ring.
PAGE 10
Optional / Opcional / Facultative 19950-DST / 4153-DST 3 4 4 2 5 5 1 1 3 RP37490 (Not Included In All Models) 3 3 6 6 7 4 7 2 6 RP37490 (Not Included In All Models) 2 7 5 3 6 8 8 1 8 9 9 Optional Escutcheon Installation Model 19950-DST / 4153-DST Place gasket (1) into groove on bottom of base ring (2). Place base ring onto sink over mounting hole, then install trim ring (3) over base ring.
PAGE 11
A. 2 C. D. 1 4 4 2 1 5 B. 3 5 4 Insert hose through spout tip only. Inserte la manguera solo a través de la punta del surtidor. 1 Introduisez le tuyau souple dans l’extrémité du bec seulement. 1 Hose Installation A. Screw the threaded fitting of hose (1) into spray head (2) to prevent the C. Feed hose assembly (1) through spout (4) and hub (5). B. Insert hose guide (3) into end of hose (1) as shown. D. Slide spout assembly onto hub. Use caution not to pinch fingers.
PAGE 12
3 A. B. 2 1 3 1 2 2 1 2 3 1 Hose Installation A. Slide hose weight (1) over end of hose (2). B. Push hose end (1) onto faucet outlet (2). Attach clip (3) over hose and outlet as shown. Pull down moderately to ensure connection has been made. Instalación De la Manguera A. Deslice la pesa de la manguera (1) sobre el extremo de la manguera (2). B. Deje pasar el extremo de la manguera (1) por la salida de la llave de agua / grifo (2).
PAGE 13
4 A. B. OR 2 2 1 O 2 OU 3 1 3 4 2 1 4 A. Water Line Connections Ensure all fittings and end connections are free of debris. Faucet fittings (1) are 3/8" compression, with ends colored red for hot and blue for cold. Loop tubing (2) if it is too long. Note: Recommended tubing minimum bend diameter is 8". Secure metal nut (3) on faucet tube to supply valve connection (4) and hand tighten, then tighten one additional turn with wrench. DO NOT OVERTIGHTEN. Repeat for other tube.
PAGE 14
Correct method Método Correcto Bonne méthode Incorrect Installation Instalación Incorrecta Installation Incorrecte 2 3 1 4 Custom Fit Connections - Plastic Sleeve Installation Instructions 1. Identify desired length of tube (1). Leave 1" - 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free. 2. Slide nut (2) and plastic sleeve (3) onto cut tube. Ensure sleeve is oriented as shown. 3. Insert tube into outlet fitting (4).
PAGE 15
5 2 6 B. A. 3 4 1 2 3 4 5 1 1 For Models with Soap Dispenser Remove the bottle (1). Separate head (2) from body assembly (3) by using a pulling and twisting motion. Make sure gasket (4) is properly seated in the base of the body assembly. Insert body assembly through selected hole in sink. Secure body assembly to sink with nut and gasket (5). From under the sink screw the bottle (1) onto the body assembly shank, then attach head assembly.
PAGE 16
7 1 2 Setting The Handle Limit Stop (Optional) This faucet includes an integrated handle limit stop that has two positions. Position 1, to the left, allows full handle motion (the full range between “all cold” to “all hot”). The faucet is set in position 1 in the factory. Position 2, to the right, allows half of the normal handle motion (“all cold” to “mixed hot/cold”). The handle limit stop can be adjusted by the homeowner once the faucet is installed.