User Manual

ManualsBrandsDelta Systems ManualsElectronicsRemote Control

OPERATING INSTRUCTIONS RC30 & RC23

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product de-

scribed. Protect yourself and others by observing all safety information. Failure to comply with these instructions could result in

personal injury and/or property damage. Retain instructions for future reference

ﬁ

Quality Winches Since 1956

General Safety Information

Throughout this manual potential safety hazards will be noted with the following terms. Please read and understand

these terms before operating the product.

Danger means a hazard

that will

cause death or se-

rious injury if the warning

is ignored.

Caution means a hazard that

may cause minor or moder-

ate injury if the warning is

ignored. It also may mean a

hazard that will only cause

damage to property

Warning means a hazard

that could

cause death or

serious injury if the warning

is ignored.

P5593100AV

07/04

“RF” REMOTE CONTROLLED

TRAILER WINCHES

WITH SPOTLIGHT

BOAT TRAILER WINCH

MODELS

RC30 (P77950)

& RC23 (P55750)

DESCRIPTION:

Trailer winches are used for launching

and unloading boats. These winches

feature power-in/free-wheel out ca-

pabilities. These winches operate by

means of a wireless remote system

within a radius of 25 feet around the

center of the winch. These winches

also come equipped with a 12-volt

spotlight to help improve visibility

while operating in hours of darkness.

UNPACKING:

When unpacking, inspect carefully for

any damage that may have occured

during transit. Make sure that any

loose ﬁ ttings, bolts, etc., are tightened

before putting unit into service.

Summary of content (10 pages)

PAGE 1
OPERATING INSTRUCTIONS RC30 & RC23 Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with these instructions could result in personal injury and/or property damage.
PAGE 2
OPERATING INSTRUCTIONS RC30 & RC23 General Safety Information (continued) The following safety precautions must be followed at all times NOTE: Note means any additional information pertaining to the product or its proper usage. The following safety precautions must be followed at all times: 1. Read all manuals included with this product carefully. Be thoroughly familiar with the controls and the proper use of the equipment.
PAGE 3
OPERATING INSTRUCTIONS RC30 & RC23 Specifications Various load conditions will affect winch performance. The line pull required for a specific application depends on the weight of the load, condition of the trailer rollers, and the degree of the loading ramp incline. The chart below is based on a single line pull and is a guideline to aid in calculating pulling requirements. NOTE: The noise level of this winch in operation is below 98db (A). CHART #1 - Approximate Rolling Load Capacities.
PAGE 4
OPERATING INSTRUCTIONS RC30 & RC23 Winch Installation MOUNTING The winch can be mounted on the trailer in the same position and location as an existing hand winch. After removing the hand winch, bolt the Powerwinch unit using a minimum of (2) 3/8” Grade 5 machine bolts and lock nuts. The Powerwinch Quick Mount Kit (P7700000AJ) is available from the dealer. The cable hook on the winch and the bow eye on the boat should be at the same height when the boat is in the fully loaded position on the trailer.
PAGE 5
OPERATING INSTRUCTIONS RC30 &RC23 Transmitter Instructions The Powerwinch RC30 and RC23 winches are equipped to operate with a radio frequency remote transmitter and receiver module (located inside of winch cover). Every transmitter and reciver module must be programmed by the operator to communicate with one another before the initial use of the winch. Please refer to the instructions below so that proper communication between the transmitter and receiver module can be established.
PAGE 6
OPERATING INSTRUCTIONS RC30 & RC23 In case you would ever lose your transmitter and have to obtain another from Powerwinch Inc, you can remove all transmitters by pressing and holding the learn button for 25 seconds with the Powerwinch head powered up. Of course you would have to repeat the learn process for a new transmitter. This Device complies With The FCC Part15. Operation is subject to the following two conditions. (1) This device may not cause harmful interference.
PAGE 7
OPERATING INSTRUCTIONS RC30 & RC23 WIRING HARNESS - + MALE PLUG (INSERT INTO FRONT OF POWER SOCKET) CIRCUIT BREAKER 12-VOLT BATTERY POWER SOCKET (REAR VIEW) BLACK WIRE 12-VOLT MOTOR SILVER TERMINAL RED WIRE GOLD TERMINAL SOLENOID MANUAL OVERIDE/LEARN SWITCH INTERNAL COIL RECEIVER MODULE BLUE WIRE RED WIRE BLACK WIRE RED WITH WHITE STRIPE WIRE (POSITIVE TO LIGHT BULB) GREEN WIRE (NEGATIVE TO LIGHT BULB) BLACK WIRE SWITCH LEAD SWITCH LIGHT BULB BLACKWIRE SWITCHLEAD DENOTES GROUNDED TO WI
PAGE 8
OPERATING INSTRUCTIONS RC30 &RC23 RC30 &RC23 Winch Troubleshooting Limited Warranty A. This Limited Warranty is given by the Powerwinch Division of the Scott Fetzer Company (the “Company”) to the original purchaser (the “Purchaser”) of a Powerwinch Product (the “Product”) specified in this manual. This Limited Warranty is not transferable to any other party. B. Responsibilities of the Company under this Limited Warranty: 1.
PAGE 9
fi Powerwinch RC23 Part Number P55750 For Replacement Parts Please Call (800) 243-3097 Powerwinch, 301 Lawton Ave, Monroe, OH 45050 (513) 539-7215
PAGE 10
fi Powerwinch RC30 Part Number P55950 For Replacement Parts Please Call (800) 243-3097