User Manual

OPERATING INSTRUCTIONS RC30 & RC23
In case you would ever lose your transmitter and have to obtain another from Powerwinch Inc, you can
remove all transmitters by pressing and holding the learn button for 25 seconds with the Powerwinch head
powered up. Of course you would have to repeat the learn process for a new transmitter.
This Device complies With The FCC Part15. Operation is subject to the following two conditions.
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Section 15.105 Information to the user
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
__Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
-- Caution any changes or modifications not expressly approved by Powerwinch voids user’s authority to
operate this equipment .
Transmitter Functions

Summary of content (1 pages)