User's Manual

ManualsBrandsDelta Networks ManualsElectronicsWiFi Module

Hardware Specification

for BSG RF Module

Block Diagram:

Processor : Atheros AR2315 single chip integrated with the MAC/baseband/radio

PHY : Realtek RTL8201 single channel, full-duplex 10/100Base-Tx transceiver

Memory : Serial Flash : 32Mbit

SDRAM : 16MByte, 16bit data bus – 1 piece of 8M x 16bit.

I/O Interface : FE , 1 x 2.4G RF SMA Conn. attaching to Antenna.

1 x 2.4G Printed Antenna

Feature :

 Wi-fi Wireless Access Point

 IEEE802.11b/g

 2.4G RF SMA Conn. attaching to Antenna.

 2.4G Printed Antenna

 Max Transmit power consumption:2.4W

 Rx Sensitivity

Summary of content (4 pages)

PAGE 1
Hardware Specification for BSG RF Module Block Diagram: Processor : Atheros AR2315 single chip integrated with the MAC/baseband/radio PHY : Realtek RTL8201 single channel, full-duplex 10/100Base-Tx transceiver Memory : Serial Flash : 32Mbit SDRAM : 16MByte, 16bit data bus – 1 piece of 8M x 16bit. I/O Interface : FE , 1 x 2.4G RF SMA Conn. attaching to Antenna. 1 x 2.4G Printed Antenna Feature : Wi-fi Wireless Access Point IEEE802.11b/g 2.4G RF SMA Conn. attaching to Antenna. 2.
PAGE 2
11g 11b Test Name Data Rate DUT Measured RX Sensitivity 6Mbps -88 RX Sensitivity 36Mbps -73 RX Sensitivity 48Mbps -70 RX Sensitivity 54Mbps -68 RX Sensitivity 1Mbps -90 RX Sensitivity 2Mbps -87 RX Sensitivity 5.5Mbps -86 RX Sensitivity 11Mbps -85 Transmit Power 11g 11b Test Name Data Rate DUT Measured Transmit power 6Mbps 17 (+1.5/-1.5) dBm Transmit power 36Mbps 16 (+1.5/-1.5) dBm Transmit power 48Mbps 15 (+1.5/-1.5) dBm Transmit power 54Mbps 14 (+1.5/-1.
PAGE 3
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 4
LABEL OF THE END PRODUCT: The final end product must be labeled in a visible area with the following " Contains TX FCC ID: XXXXX ". If the size of the end product is larger than 8x10cm, then the following FCC part 15.19 statement has to also be available on the label: This device complies with Part 15 of FCC rules.