User's Manual

ManualsBrandsDelta Electronics ManualsElectronicsBluetooth Module

U-TEL v. 050401

Bluetooth Module

Quick Installation Guide

FCC Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the specific operating instructions for satisfying RF

exposure compliance. This transmitter must not be co-located or operating in conjunction

with any other antenna or transmitter. Notice: Any changes or modification not expressly

approved by the party responsible could void the user’s authority to operate the device.

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

Product Introduction

The Bluetooth Module allows a computer with a USB port to communicate with other

Bluetooth-enabled devices. When used with the Bluetooth application software, it can

perform wireless network applications such as information exchange, file transfer, network

access, dial-up networking, headset, audio gateway, printer application, and so on.

Package Contents

- Installation CD ROM

- Bluetooth Module interface USB

- Quick Installation Guide

System Requirements

- IBM compatible PC with Pentium, Celeron™ processor or equivalent CPU or higher.

- RAM 64M or above

- Screen: 800*600 or above

- Display: adapter True Color 16bits or above.

- Microsoft® Windows® 98SE/ME/2000/XP

Installation Steps

Step 1: Uninstall previous version of BlueSoleil, IVT BSS or MiniBluelet. If a previous

version of BlueSoleil, IVT BSS or MiniBluelet has been installed, it is

recommended to uninstall it first and restart the computer before installation. You

can use uninstall tools uninstall.exe” in the installation package.

PDF created with pdfFactory trial version www.pdffactory.com

Summary of content (6 pages)

PAGE 1
Bluetooth Module Quick Installation Guide FCC Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Notice: Any changes or modification not expressly approved by the party responsible could void the user’s authority to operate the device.
PAGE 2
Step 2: Insert the Installation software CD into the CD-ROM of your machine. Step 3: Launch the Setup.exe program in the installation CD ROM. In normal cases, you can follow the instructions to finish the software installation. Step 4: Restart the Computer. After the BlueSoleil software package is installed, you will need to restart the computer. This is to make sure that the installed Bluetooth Device takes effect.
PAGE 3
Note: 1. For Windows 98 and Windows ME, the Dial-up Adapter and Windows’s component direct cable connection and NETBEUI protocol needs to be installed to run the Dial-up Networking profile and LAN access profile. 2. You need configure Bluetooth Network Adapter IP to run PAN profile. 3. More details on how to use IVT BlueSoleil, please refer to Online Help, User Manual and any other support document. 4. If some system exceptions occur during the installation, please use uninstall.
PAGE 4
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
PAGE 5
The user manual of the final host system must contain the following statements: USA-Federal Communications Commission (FCC) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy.
PAGE 6
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Caution: Exposure to Radio Frequency Radiation. This device must not be co-located or operating in conjunction with any other antenna or transmitter.