Sicherheitsmainahmen und Wartung # Den Monitor von der Netzspannung trennen, wenn der Monitor langer Zeit nicht benutzt wird. ® Versuchen Sie nicht, die werksseitige Abdeckung zu entfernen, da hierdurch stromfressende Teile freigelegt werden und die Gefahr von elektrischen Schlagen besteht.
Federal communications commission (FCC) Statement This equipment has been tested and found to comply with the limits jor a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference ina residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications.
IMPORTANT SAFETY INSTRUCTIONS 1. SEE INSTALLATION INSTRUCTIONS BEFORE CONNECTING TO THE SUPPLY 2. THE APPLIANCE COUPLET IS CONSIDERED AS A DISCONNECT DEVICE. SHALL BE CONNECTED AS CLOSELY AS PRACTICABLE TO THE INCOMING SUPPLY, 3. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE. 4. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. 5.
TABLE OF CONTENTS INTRODUCTION oie 8 INSTALLATION INSTRUCTIONS .
INTRODUCTION ‘We would like to thank you for your purchase of this color monitor. This monitor set can be used with IBM PC/XT/AT and PS$/2 computers of compatibles with analog RGB output. It also supports timings of graphics adapters including: VGA, Super VGA, XGA, 1024x768. This manual covers the specifications for models DD-556AA, DD-556BA. Please read this manual carefully to obtain the best performance from your monitor. Keep this manual for future reference.
INSTALLATION INSTRUCTIONS CAUTION: Be sure fo turn off the AC Power to the monitor before making connections 1. Assemble the tilt/swivel base as shown below. 2. Connect the power cord as shown on page 8. 3.
USING THE RIGHT POWER CORD FOR 230V AC For units used at 120V: Use a UL Listed cord set consisting of a minimum NO. 18 AWG, Type SVT or SJT, rated BA minimum 125, three-conductor cord a maximum length and a parallel blade, grounding type attachment plug. For units used at 230V {domestic use): Use a UL Listed cord set consisting of a minimum No. 18 AWG, Type SVT or SJT, rated 3A Minimum 250V, three conductor cord a maximum length and a tandem blade, grounding type attachment plug.
HOT KEY ADJUSTMENT At Default State (screen without OSGOOD. there are 2 hol keys for adjustment. Push (En) button to show contrast and brightness icons on the screen: [CD Push to select contrast or brightness control. (Pp Push [SD] or a to adjust the level of contrast. Lr push (or CF to adjust the level of brightness. PushtoexitOSD.
SPECIFICATIONS MODEL DD-556 AA SIZE 15" DIAGONAL (> 13.8" VIEWABLE) CRT [DEFLECTION ANGLE 90 DEGREES PHOSPHOR PITCH 0.28 mm SCREEN DOT TYPE.
POWER MANAGEMENT THIS MONITOR CAN SUPPORT VASE POWER MANAGEMENT SYSTEM, INDICATED BY THE LED ON THE FRONT PANEL: STATE LDE COLOR | POWER CONSUMPTION ON GREEN 80W STAND BY/ AMBER < 15W SUSPEND ACTIVE OFF AMBER < BW “The monitor remains in the power-saving state until you press a key on the keyboard or move the mouse (if available). DISPLAY DATA CHANNEL (DDC) COMMUNICATION CHANNEL TYPE: VASE DDC1/2B ESTABLISHED TIMINGS: AS PRESET TIMING CHARTS.
TROUBLESHOOTING GUIDE if your monitor is not performing properly, please use the following troubleshooting chart for quick solutions. to common problems. if the problem persists, call your monitor dealer for assistance. Problem Possible Cause Remedy No picture Is the power cord connected? 1s the power switch on? Is the signal cable properly connected? Is the monitor in the power save mode? Connect power cord. Turn on power switch. Connect signal cable properly. Check connector for bent pins.
ADDITIONAL INFORMATION Helpful Hints ® Avoid exposing the monitor to direct sunlight or other heal source # Keep the monitor away from magnets, motors, transformers, speakers and televisions ®» Do not place heavy objects on the cable or power cord. Safety Tips ® If smoke, abnormal noise or foul odor is present, immediately switch the monitor off and call your dealer. It is dangerous to continue using the monitor. # Never remove the rear cover. The display unit contains high-voltage parts.