User Guide Premium Sound System (SKYFi3 receiver sold separately) Important: This manual contains important safety and operating information. Please read, understand, and follow the instructions in this manual. Failure to do so could result in personal injury, death, and/or damage to your Delphi Premium Sound System, accessories, and/or to your vehicle or property.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. Warning: To prevent fire or shock hazard, do not expose the Delphi Premium Sound System to rain, moisture or water. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.
Owner’s Record The model number is located below and the serial number is located on the label on the rear of the Delphi Premium Sound System. Record the serial number in the space provided below. Refer to these numbers whenever you call your dealer regarding this product. Model No.: DELPHI SA10221 Serial No.
Delphi Premium Sound System Controls: VOL- volume down BASS bass boost VOL+ volume up
Need help? Call us at 1.877.GO.DELPHI Monday through Friday from 8:00 a.m. - 8:00 p.m. Eastern Time Saturday and Sunday from 10:00 a.m. - 4 :00 p.m Eastern Time Note: Extended seasonal hours may be available. Thank you for purchasing the Delphi Premium Sound System. We’ve designed many thoughtful features into this system to ensure that your level of listening enjoyment is the very best it can be.
Table of Contents Contents Welcome................................................................ 3 About Delphi......................................................... 3 Getting Started..................................................... 4 What’s in the Box.................................................. 4 Setting up the System.......................................... 5 Installing the Cradle.............................................. 6 Power up the System..........................................
Welcome Thank you for purchasing the new Delphi Premium Sound System. You are just minutes away from being able to play crystal clear live XM® satellite radio on a precisely engineered speaker system. Please read the following pages to get started with your new Delphi Premium Sound System. About Delphi Delphi is a world leader in mobile electronics, vehicle components and audio technology.
Getting Started What’s In the Box Your Delphi Premium Sound System Kit contains the following components: Items in the box 1. Premium Sound System 2. Radio cradle inserts for Roady® XT, MyFi®, SKYFi3® and Audiovox® receivers 3. Repeater Antenna Bracket and mounting screws 4. 18 volt power supply with separate cord (not pictured) 5. User Guide (not pictured) 6.
Getting Started Setting Up the System You can set up your Delphi Premium Sound System by following these steps: 1. Connect the supplied 18-volt DC power adaptor to the jack on the rear of the Delphi Premium Sound System. Plug the other end into the wall outlet. You may also use 8 “C” batteries (not included). 2. The XM Antenna is located under the top cover of the Delphi Premium Sound System. If needed (i.e.
Getting Started to attach the antenna to the four tabs on the back of the Delphi Premium Sound System. Or you can extend the entire 20’ cable away from the system to improve reception.To reattach the top cover, line up all tabs and then slide the cover toward the front of the unit until a click is heard. Make certain that all tabs are engaged and the rear of the panel is aligned with the rear cover.
Getting Started Power Up the System Use the power button on the receiver or on its remote control to turn on the receiver. If the display reads “ANTENNA” after powering up, check that the antenna connection is secure and completely pushed in. Next, change channels (from 0 to 1 or from 1 to 0 if the receiver is not authorized yet). NOTE: Some receivers will power up automatically when installed in the Delphi Premium Sound System.
Getting Started Using SKYFi3® with Delphi Premium Sound System 1. Install the SKYFi3 cradle insert onto the Delphi Premium Sound System. Insert the SKYFi3 receiver (sold separately) into the cradle insert included with the Delphi Premium Sound System until snug. Caution: Do not use excessive force when inserting the receiver into the cradle. Doing so could cause damage to the unit. 2.
Getting Started 4. If the display reads “NO SIGNAL” after powering up, follow the instructions in “Setting up the Antenna” on page 18. NOTE: Getting started instructions on all receivers are the same with the exception of having to turn on the MyFi on the receiver and adjusting the separate volume control on that receiver as well.
Getting Started Using MyFi® with Delphi Premium Sound System Special note for MyFi receivers: If you have purchased the MyFi unit, you must turn on the MyFi switch located in the battery compartment of the Premium Sound System. Sliding this switch to “2” position will make the Premium Sound System compatible with MyFi radios. For all other radios this switch should be in “1” position and the Premium Sound System should operate normally.
Getting Started Switch to “2” position to use your MyFi with the Delphi Premium Sound System.
Getting Started Using Roady® XT with Delphi Premium Sound System 1. Install the Roady XT cradle onto the Delphi Premium Sound System. Insert the Roady XT Receiver (sold separately) into the adaptor included with the Delphi Premium Sound System until snug. Caution: Do not use excessive force when inserting the receiver into the cradle. Doing so could cause damage to the unit. 2.
Getting Started 4. I f the display reads “NO SIGNAL” after powering up, follow the instructions in “Setting up the Antenna” on page 18.
Getting Started Using an Audiovox® Receiver with Delphi Premium Sound System 1. Install the Audiovox cradle onto the Delphi Premium Sound System. Insert the Audiovox receiver (sold separately) into the cradle insert included with the system until snug. Caution: Do not use excessive force when inserting the receiver into the cradle. Doing so could cause damage to the unit. 2.
Getting Started 4. I f the display reads “NO SIGNAL” after powering up, follow the instructions in “Setting up the Antenna” on page 18.
Getting Started Using the Delphi Premium Sound System with Batteries The Delphi Premium Sound System can be used with batteries (not included) to allow you to listen to XM outdoors or in other locations without access to an AC power source. Alkaline or rechargeable NiCD batteries are recommended. Battery life will vary depending on how the system is operated and the type of batteries being used.
Getting Started Back Cover Battery Switch To keep the batteries from draining when not in use, switch the button to OFF position. The function of the Battery switch in the rear is to provide protection against battery drainage when Premium Sound System is not plugged into the wall.
Setting Up the Antenna The antenna that comes with the Delphi Premium Sound System is a high-gain antenna that can receive the XM signal from XM’s satellites and/or XM’s land-based repeaters (depending on where you live). It is recommended that the antenna be positioned near a south-facing window or outdoors with a clear view of the southern sky in order to receive the satellite signal. In some cases, it will be possible to receive the XM signal through standard home walls or a roof.
Setting Up the Antenna Caution: Do not set anything on top of the Premium Sound System as it may reduce antenna signal reception. Positioning the Antenna When outdoors with a view of the southern sky, or in an area of repeater coverage, or when receiving a strong signal indoors, you can conveniently leave the antenna under the top cover and secure the wires under the cover. 1.
Setting Up the Antenna Indoor Installation on a Flat Surface To aim your antenna at the satellite: 1. Set antenna flat against its base on a flat (horizontal) surface. 2. Turn the base of the antenna so that the XM logo is facing to the south. 3. Use the “Antenna Aiming” screen to optimize antenna tilt angle and position. 4. If necessary, experiment with different locations near a south-facing window or outdoors. Your antenna comes with 20’ of cable.
Setting Up the Antenna 2. Attach four screws to the wall using the screw-locator pattern shown below. Photocopy the pattern to use as a template. Use screws with head sizes small enough to fit in the center of each of the four holes but large enough not to pop out of the elongated sections. Leave 1/8” of the screw shanks behind the heads sticking out of the wall. Photocopy this diagram of the screw-locator pattern on the bottom of your XM Antenna to use as a template for wall attachment.
Setting Up the Antenna 3. Tilt the antenna fully back on the base. Place the antenna base on the four screw heads with the antenna pivot at the top and pull down approximately 1/4” until the base is firmly secured. Note that the XM logo will be upside down when the antenna is properly installed. 4. Tilt the antenna away from the wall/base until the signal is optimized. Note: DO NOT CUT THE ANTENNA CABLE and attempt to splice it or attach alternative connectors or cable.
Setting Up the Antenna Repeater Antenna The Delphi Premium Sound System comes with a repeater antenna bracket. This bracket can be attached to base of the unit using the two screws provided with the bracket. Once the bracket is attached to the audio system, the repeater antenna can be snapped in place and the wire can be routed through the opening provided in the rear under the top cover. Plug the antenna into the connector and secure the access wire to the cover. The top cover can now be snapped in place.
Using the Delphi Premium Sound System Unique Delphi Premium Sound System features include the following: Volume Volume can be adjusted using the push buttons on the Delphi Premium Sound System. In addition, when the receiver is connected to the Delphi Premium Sound System, the + and - controls on the receiver’s remote control can also be used to increase (+) and decrease (-) volume. VOL- BASS VOL+ Note that the “Line Out Level” cannot be reset while the receiver is in the Delphi Premium Sound System.
Using the Delphi Premium Sound System Bass Boost Delphi Premium Sound System is equipped with Maxx Bass technology. To turn on the additional bass press the BASS Boost (see illustration at left). Additional Bass & Treble adjustment in the satellite radio: If your attached satellite radio has built-in EQ settings, bass and treble can be adjusted by pressing the “Menu” button, selecting “Bass + Treble,” and then setting them in the same manner as other menu functions.
Using the Delphi Premium Sound System sound. Sound that seems normal can be loud and harmful to your hearing. Take precautions by adjusting the volume control on your audio system to a safe sound level before your hearing adapts to it. To help avoid hearing loss or damage, do the following: 1. Adjust the volume control to the lowest setting. 2. Increase volume slowly until you hear comfortably and clearly.
Other Things You Should Know Precautions 1. On power sources: •F or AC operation, it is recommended that only the supplied AC power adaptor is used. •T he satellite radio receiver should not be disconnected from the AC power source as long as it is connected to the wall outlet, even if the satellite radio receiver has been turned off or detached. •U nplug the AC power adaptor from the wall outlet when it is not used for an extended period of time. •F or battery operation, use 8 “C” size batteries.
Other Things You Should Know 3. Do not immerse in water. •T his product is not meant to be immersed in water or come in continuous contact with water. •B efore opening or shutting the receiver cradle or battery compartment panel, be sure to wipe off water, dust, or sand on the outside of the unit. • I f the Delphi Premium Sound System is splashed with salt water, wipe clean with a damp cloth, and then dry with a soft dry cloth.
Other Things You Should Know If there is no audio: • Unplug the satellite radio receiver from the Delphi Premium Sound System and re-insert it. • Make sure that Audio level is set correctly. • Make sure that radio is not muted. If noise is heard coming through the Delphi Premium Sound System: • Someone is using a portable telephone or other equipment that emits radio waves near the antenna (~2.3GHz). To solve this problem, move the portable telephone, etc. away from the unit.
Other Things You Should Know Specifications Frequency Response..................................................30Hz to 20kHz Headphone Connector Type......................................3.5mm Stereo Jack (1/8”) Auxiliary Connector Type...........................................3.5mm Stereo Jack (1/8”) Battery Type/Qty.........................................................“C” Cell / 8 Total Overall Dimensions....................................................L15.7” x H7.8” x W8.3” .....................
Warranty Delphi Limited Consumer Warranty (United States) Delphi Product and Service Solutions (“Delphi”) warrants all XM Satellite Radio Products sold by Delphi (each “Product”) to be free of defects in material and workmanship, subject to the following conditions: The duration of Delphi’s warranty with respect to each Product is limited to one (1) year from the date of sale to the original consumer purchaser. NO OTHER EXPRESS WARRANTIES ARE MADE WITH RESPECT TO ANY PRODUCT.
Warranty installation of a Product in a manner which is inconsistent with Delphi’s written instructions, (iii) alteration or modification of a Product, (iv) misuse, (v) neglect, (vi) abuse, (vii) accident, (viii) normal wear and tear, (ix) commercial use, (x) improper storage, (xi) environmental conditions, including excessive temperature or humidity, (xii) service by anyone other than a Delphi authorized repair facility, (xiii) other improper application, installation or operation of this Product, or (xiv
Warranty gives you specific legal rights. You may also have other rights that may vary from state to state. NO PERSON IS AUTHORIZED BY DELPHI TO MODIFY OR ADD TO THIS LIMITED WARRANTY.
Warranty warranty only extends to customers who purchase the Products in Canada.
Warranty How provincial law relates to the warranty: Some provinces do not allow limitations on the duration of implied conditions or warranties, or the exclusion or the limitation of Economic Loss. So the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights. You may also have other rights that may vary from province to province. NO PERSON IS AUTHORIZED BY DELPHI TO MODIFY OR ADD TO THIS LIMITED WARRANTY.
Delphi Corporation 1441 West Long Lake Road Troy, Michigan 48098-5090 U.S.A. Customer Service: 1.877.GO.DELPHI www.delphi.com SKYFi3, Roady XT, The XM name, TuneSelect, and related logos are trademarks of XM Satellite Radio Inc. Xpress by Audiovox is a trademark of the Audiovox Electronics Corporation. MaxxBass and Maxx logo are registered trademarks of Waves Audio Ltd. in the United States and other countries. MyFi is a trademark of Delphi Corporation. ©2007 Delphi Corporation.