User's Manual

ManualsBrandsDelphi Electronics & Safety ManualsElectronicsVehicle Radar Sensor

Re: Certification for Delphi Delco SR Radar

PN: 09369080

FCC ID: L2C0015TR

CANADA: to be provided by IC

USER'S MANUAL INFORMATION

(PRELIMINARY)

The Vehicle User's Manual is in preparation. The following material will be contained in

the manual:

FCC ID: L2C0015TR CANADA: to be provided by IC

This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry

Canada. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that

may cause undesired operation.

WARNING: Changes or modifications not expressively approved by the party

responsible for compliance could void the user's authority to operate the equipment.

Summary of content (9 pages)

PAGE 1
Re: Certification for Delphi Delco SR Radar PN: 09369080 FCC ID: L2C0015TR CANADA: to be provided by IC USER'S MANUAL INFORMATION (PRELIMINARY) The Vehicle User's Manual is in preparation. The following material will be contained in the manual: FCC ID: L2C0015TR CANADA: to be provided by IC This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
PAGE 2
XK SERIES DRIVERS HANDBOOK SUPPLEMENT JJM 13 02 14/001
PAGE 3
2 Adaptive Cruise Control Adaptive Cruise Control (ACC) For your added comfort and convenience this vehicle is fitted with adaptive cruise control. This system maintains a gap from the vehicle ahead or a set road speed if there is no slower vehicle ahead. The system is intended to provide enhanced operation of the vehicle when following other vehicles which are in the same lane and travelling in the same direction.
PAGE 4
Adaptive Cruise Control 3 Press the ‘SET +’ button (B) briefly and the vehicle speed will then be stored in the memory and the system engaged. The set speed will be displayed on the message centre.
PAGE 5
4 Adaptive Cruise Control The vehicle will then maintain the constant time gap to the vehicle ahead until: • the vehicle ahead accelerates to a speed above the set speed. • the vehicle ahead moves out of lane or out of view. • the vehicle ahead slows so that ‘low speed automatic switch off’ occurs. • a new gap distance is set. If necessary, the vehicle brakes will be automatically applied to slow the vehicle to maintain the gap to the vehicle in front.
PAGE 6
Adaptive Cruise Control 5 Changing the set speed There are three ways to change the set speed: 1. Accelerate or brake to the required speed and press the ‘SET +’ button (B). 2. Increase or decrease the speed by pressing and holding either the ‘SET +’ (B) or ‘–’ (G) button until the required set speed is shown on the message centre. The vehicle speed will gradually change to the selected speed. 3. Increase or decrease the speed in steps of 2 km/h (1 mph) by briefly pressing the ‘SET +’ (B) or ‘–’ (G) button.
PAGE 7
6 Adaptive Cruise Control ACC failure If a fault occurs during operation of the system in cruise or follow modes, the ACC system will switch OFF and will not be able to be used until the fault is cleared. A red warning light will be displayed accompanied by the message ‘DRIVER INTERVENE’ on the message centre. If failure of the ACC or any related system occurs at any other time an amber warning light will be displayed accompanied by the message ‘CRUISE NOT AVAILABLE’.
PAGE 8
Adaptive Cruise Control 7 Detection problems can also occur: • when driving on a different line to the vehicle in front (illustration above) or JWK-185 There may be problems with the detection of vehicles in front when going into and coming out of a bend. • with vehicles which edge into your lane which can only be detected once they have moved fully into your lane (lower illustration).
PAGE 9
8 Adaptive Cruise Control