Dell EMC XC730xd-12C Series Hyper-Converged Appliance Support Matrix December 2020 Dell EMC Support Matrix
Revisions Revisions Date Description December 2020 Updated Supported management software September 2019 Updated the following sections: • • • Supported NICs and NDCs Supported Management Software Supported Hypervisor OS February 2020 Updated the Supported Hypervisor OS June 2019 Updated the following sections: • • August 2018 Supported Management Software Supported Hypervisor OS Updated firmware and BIOS. March 21, 2018 Updated NIC firmware. March 2018 Updated Firmware and BIOS.
Table of contents Table of contents Revisions............................................................................................................................................................................. 2 Table of contents ................................................................................................................................................................ 3 Introduction ................................................................................................
Introduction Introduction This document provides information about the supported software, firmware, and hardware versions and technical specifications for the Dell EMC XC730xd-12C Series Hyper-Converged Appliance. NOTE: Future updates to this document may remove firmware versions because Nutanix LCM is the prescribed method to update the appliance. NOTE: This Support Matrix contains the latest compatibility and interoperability information.
Technical specifications 1.4 BIOS iDRAC 2.1.6 2.40.40.03 2.2.4 2.40.40.40 2.3.4 2.40.40.40 2.4.3 2.41.40.40 2.6.0 2.50.50.50 2.7.1 2.52.52.52 2.8.0 2.60.60.60 Supported physical disk drives This section provides information about disks drives supported by your hardware. Supported Physical Disk Drives 5 Form Factor Capacity Type Vendor 2.5" 1 TB NL-SAS HDD Dell EMC Supported 2.5" 1.2 TB SAS HDD Dell EMC Supported 2.5" 2 TB NL-SAS Dell EMC Supported 2.
Technical specifications 1.5 Form Factor Capacity Type Vendor 3.5" 4 TB SED HDD Dell EMC Supported 3.5" 6 TB SED HDD Dell EMC Supported 2.5" 480 GB SATA SSD Samsung 2.5" 960 GB SATA SSD Samsung 2.5" 1920 GB SATA SSD Samsung 3.5" 3840 GB SAS SSD Toshiba 2.5" 480 GB SATA SSD Intel 2.5" 960 GB SATA SSD Intel 2.5" 1920 GB SATA SSD Intel Supported HBAs This section provides information about Host Bus Adapters (HBA) supported by your hardware.
Technical specifications WARNING: Hot-plugging an unsupported SFP+ module causes ESXi host to fail with purple diagnostic screen. Call Dell EMC Support to recover from this situation. Supported NICs and NDCs Vendor Description Chipset Intel CRD,NTWK,10G BASET,DP,INTEL,LP x540 CRD,NTWK,12G,RNDC,INTEL,10GSFP x540/i350 1.
Technical specifications 1.8 Supported management software This section provides information about components supported by your hardware. Supported management software 1.9 Name AOS version (Skylake) AOS version (Cascade lake) AHV 5.1 or later 5.10.3.2 or later Windows Server 2016 5.5.0.4 or later 5.10.3.2 or later Windows Server 2019 5.17 or later 5.17 or later ESXi 6.0U3 (EOL date 3/12/2020) 5.1 or later 5.10.3.2 or later ESXi 6.5d 5.1 or later 5.10.3.2 or later ESXi 6.
Technical specifications 2 Technical specifications 2.1 Physical specifications This chapter provides technical specifications for appliance. This section provides expansion physical specifications for storage, including height, width, depth, maximum configuration weight and empty weight. Physical specifications 2.2 Physical Specification Height 8.73 cm (3.44 inch) Width 48.2 cm (18.98 inch) Depth 75.58 cm (29.75 inch) Weight (Maximum) 36.5 kg (80.47 lb.) (3.
Technical specifications 2.4 Power specifications This section provides power specifications for your hardware, including wattage, heat dissipation, and voltage. NOTE: This system is also designed to connect to IT power systems with a phase to phase voltage not exceeding 230 V. Power Specifications Type Specification AC power supply unit (PSU) Wattage 495 W, 750 W, or 1100 W Heat dissipation 1908 BTU/hr. maximum (495 W PSU) NOTE: Heat dissipation is calculated on the 2891 BTU/hr.
Technical specifications Memory Specification 64 GB with a dual processor 2.6 Hard drive specification This section provides hard drive specifications for your hardware. Hard drive specification 2.7 Type Specification Twelve hard-drive systems Up to twelve 3.5- inch drives Connector specifications This section provides connectors specifications for your hardware, including rear, front, and internal connectors.
Technical specifications 2.8 Video specifications This section provides video specifications for storage, including type, and memory. Video specifications 2.9 Type Specification Video type Matrox G200eR2 Video memory 16 MB Environmental specifications This section provides environmental specifications for storage, including temperature, relative humidity, maximum vibrations, particulate contamination, gaseous contamination, and expanded operating temperature.
Technical specifications Type Specification Operating 3,048 m (10,000 ft) Storage 12,000 m (39,370 ft) Operating altitude de-rating Up to 35°C (95°F) Maximum temperature is reduced by 1°C/300 m (1°F/547 ft) above 950 m (3,117 ft). 35°C to 40°C (95°F to 104°F) Maximum temperature is reduced by 1°C/175 m (1°F/319 ft) above 950 m (3,117 ft). Particulate contamination NOTE: This section defines the limits to help avoid IT equipment damage and/or failure from particulates and gaseous contamination.
Technical specifications Type Specification Note: When operating in the expanded temperature range, ambient temperature warnings may be reported on the LCD and in the System Event Log. Continuous operation 5°C to 40°C at 5% to 85% RH with 29°C dew point. NOTE: Outside the standard operating temperature (10°C to 35°C), the system can operate continuously down to 5°C or as high as 40°C.
Documentation matrix 3 Documentation matrix The documentation matrix provides information about the documents that you use to configure and deploy the Dell EMC Hyper-Converged Appliance solution. WARNING: See the safety and regulatory information that shipped with your system. Warranty information may be included with this document or as a separate document.
Documentation matrix 3.2 To learn about... Refer to... Setting up and using Dell EMC iDRAC8 Dell EMC iDRAC8 Quick Start Guide Using OpenManage Essentials to monitor, perform updates, view hardware, and view inventory on your system Dell EMC OpenManage Essentials User's Guide Nutanix documentation Nutanix documentation is found using the Nutanix portal found at https://portal.nutanix.com/#/page/docs. To display a complete set of documentation, you must have user credentials to log in.
Documentation matrix To learn about... Acropolis base document name Comprehensive instructions and references for Prism Web Console Guide the Nutanix UI, including overview information. Monitoring multiple Nutanix cluster through web console.
Contacting Dell EMC 4 Contacting Dell EMC Dell EMC provides several online and telephone-based support and service options. If you do not have an active internet connection, you can find contact information about your purchase invoice, packing slip, bill, or Dell EMC product catalog. Availability varies by country and product, and some services may not be available in your area. To contact Dell EMC for sales, technical assistance, or customer-service issues: 1. Go to Dell.com/support. 2.
Quick Resource Locator 5 19 Quick Resource Locator Use the Quick Resource Locator (QRL) to get immediate access to Dell EMC XC730xd-12C solution information. This information provides access to reference documentation, a link to the Dell EMC support page, and links to hardware-specific QRL pages, which include how-to videos. You can access this information by visiting www.dell.com/QRL or by using your smartphone or tablet and scanning the QR code below.