Dell EMC XC730xd-12C Series Hyper-Converged Appliance Support Matrix February 2021 Dell EMC Support Matrix
Revisions Revisions Date Description February 2021 Updated the following sections: • • • • • • Validated BIOS and iDRAC versions Supported HBAs Supported hardware management solutions Supported Nutanix AOS software Supported hypervisor OSs Added the Driver support section December 2020 Updated Supported management software September 2019 Updated the following sections: • • • Supported NICs and NDCs Supported Management Software Supported Hypervisor OS February 2020 Updated the Supported Hypervisor
Revisions The information in this publication is provided “as is.” Dell Inc. makes no representations or warranties of any kind with respect to the information in this publication, and specifically disclaims implied warranties of merchantability or fitness for a particular purpose. Use, copying, and distribution of any software described in this publication requires an applicable software license. © 2021 Dell Inc. or its subsidiaries. All Rights Reserved.
Table of contents Table of contents Revisions............................................................................................................................................................................. 2 Table of contents ................................................................................................................................................................ 4 Introduction ................................................................................................
Introduction Introduction This document provides information about the supported software, firmware, and hardware versions and technical specifications for the Dell EMC XC730xd-12C Series Hyper-Converged Appliance. NOTE: Future updates to this document may remove firmware versions because Nutanix LCM is the prescribed method to update the appliance. NOTE: This Support Matrix contains the latest compatibility and interoperability information.
Technical specifications 1.4 Supported physical disk drives This section provides information about disks drives supported by your hardware. Supported Physical Disk Drives 6 Form Factor Capacity Type Vendor 2.5" 1 TB NL-SAS HDD Dell EMC Supported 2.5" 1.2 TB SAS HDD Dell EMC Supported 2.5" 2 TB NL-SAS Dell EMC Supported 2.5" 1 TB SED HDD Dell EMC Supported 2.5" 1.2 TB SED HDD Dell EMC Supported 2.5" 2 TB SED HDD Dell EMC Supported 2.5" 200 GB SATA SSD Intel 2.
Technical specifications 1.5 Supported HBAs This section provides information about Host Bus Adapters (HBA) supported by your hardware. Supported HBAs Name Form factor/Slot Minimum firmware Latest version version H730 Mini or integrated slot 25.3.0-0016 25.5.7.0005 HBA330 Mini or integrated slot 9.17.20.07 15.17.09.06 NOTE: This version is supported on AOS 4.1.3.x. 1.6 Supported networking This section provides information about networking supported by your hardware and supported NICs.
Technical specifications Supported hardware management solutions Name Minimum firmware version Dell EMC OpenManage Essentials (Monitoring 2.
Technical specifications 1.8 Supported Nutanix AOS software This section provides information about hypervisor release compared to Nutanix AOS release. Refer to Nutanix AOS Product support for current releases located here. Supported management software 1.9 Name AOS version AHV 5.1 or later Windows Server 2016 5.5.0.4 or later Windows Server 2019 5.17 or later ESXi 6.5d 5.1 or later ESXi 6.7 (all updates) 5.9 or later ESXi 7.0 Foundation 4.5.4.2 or later AOS 5.18 or later AOS 5.15.
Technical specifications Supported hypervisor Oss Name 1.10 Minimum version required VMware ESXi 6.0 U3 (EOL date 3/12/2020) ESXi 6.5d, 6.5U1, 6.5U2, 6.5U3 ESXi 6.7, 6.7U1, 6.7U2, 6.7U3 ESXi 7.0, ESXi 7.0 U1 Windows Server Windows Server 2012 R2 (EOL) Server Windows 2016 with GUI (OEM) Server Windows 2016 with GUI or Core (VL) Windows Server 2019 with GUI or Core (VL) Acropolis Hypervisor (AHV) AHV 5.
Technical specifications 2 Technical specifications 2.1 Physical specifications This chapter provides technical specifications for appliance. This section provides expansion physical specifications for storage, including height, width, depth, maximum configuration weight and empty weight. Physical specifications 2.2 Physical Specification Height 8.73 cm (3.44 inch) Width 48.2 cm (18.98 inch) Depth 75.58 cm (29.75 inch) Weight (Maximum) 36.5 kg (80.47 lb.) (3.
Technical specifications 2.4 Power specifications This section provides power specifications for your hardware, including wattage, heat dissipation, and voltage. NOTE: This system is also designed to connect to IT power systems with a phase to phase voltage not exceeding 230 V. Power Specifications Type Specification AC power supply unit (PSU) Wattage 495 W, 750 W, or 1100 W Heat dissipation 1908 BTU/hr. maximum (495 W PSU) NOTE: Heat dissipation is calculated on the 2891 BTU/hr.
Technical specifications Memory Specification 64 GB with a dual processor 2.6 Hard drive specification This section provides hard drive specifications for your hardware. Hard drive specification 2.7 Type Specification Twelve hard-drive systems Up to twelve 3.5- inch drives Connector specifications This section provides connectors specifications for your hardware, including rear, front, and internal connectors.
Technical specifications 2.8 Video specifications This section provides video specifications for storage, including type, and memory. Video specifications 2.9 Type Specification Video type Matrox G200eR2 Video memory 16 MB Environmental specifications This section provides environmental specifications for storage, including temperature, relative humidity, maximum vibrations, particulate contamination, gaseous contamination, and expanded operating temperature.
Technical specifications Type Specification Operating 3,048 m (10,000 ft) Storage 12,000 m (39,370 ft) Operating altitude de-rating Up to 35°C (95°F) Maximum temperature is reduced by 1°C/300 m (1°F/547 ft) above 950 m (3,117 ft). 35°C to 40°C (95°F to 104°F) Maximum temperature is reduced by 1°C/175 m (1°F/319 ft) above 950 m (3,117 ft). Particulate contamination NOTE: This section defines the limits to help avoid IT equipment damage and/or failure from particulates and gaseous contamination.
Technical specifications Type Specification Note: When operating in the expanded temperature range, ambient temperature warnings may be reported on the LCD and in the System Event Log. Continuous operation 5°C to 40°C at 5% to 85% RH with 29°C dew point. NOTE: Outside the standard operating temperature (10°C to 35°C), the system can operate continuously down to 5°C or as high as 40°C.
Documentation matrix 3 Documentation matrix The documentation matrix provides information about the documents that you use to configure and deploy the Dell EMC Hyper-Converged Appliance solution. WARNING: See the safety and regulatory information that shipped with your system. Warranty information may be included with this document or as a separate document.
Documentation matrix 3.2 To learn about... Refer to... Setting up and using Dell EMC iDRAC8 Dell EMC iDRAC8 Quick Start Guide Using OpenManage Essentials to monitor, perform updates, view hardware, and view inventory on your system Dell EMC OpenManage Essentials User's Guide Nutanix documentation Nutanix documentation is found using the Nutanix portal found at https://portal.nutanix.com/#/page/docs. To display a complete set of documentation, you must have user credentials to log in.
Documentation matrix To learn about... Acropolis base document name Comprehensive instructions and references for Prism Web Console Guide the Nutanix UI, including overview information. Monitoring multiple Nutanix cluster through web console.
Contacting Dell EMC 4 Contacting Dell EMC Dell EMC provides several online and telephone-based support and service options. If you do not have an active internet connection, you can find contact information about your purchase invoice, packing slip, bill, or Dell EMC product catalog. Availability varies by country and product, and some services may not be available in your area. To contact Dell EMC for sales, technical assistance, or customer-service issues: 1. Go to Dell.com/support. 2.
Quick Resource Locator 5 21 Quick Resource Locator Use the Quick Resource Locator (QRL) to get immediate access to Dell EMC XC730xd-12C solution information. This information provides access to reference documentation, a link to the Dell EMC support page, and links to hardware-specific QRL pages, which include how-to videos. You can access this information by visiting www.dell.com/QRL or by using your smartphone or tablet and scanning the QR code below.