Dell EMC XC6320 Series Hyper-Converged Appliance Support Matrix February 2021 Dell EMC Support Matrix
Revisions Revisions Date Description February 2021 Updated the following sections: • • • • • • Supported physical disk drives Supported networking Supported NICs Supported Nutanix AOS software Supported hypervisor OSs Physical specifications Added: • Driver support section December 2020 Updated supported management software. February 2020 Updated the Supported hypervisor OS section. August 2018 Updated Firmware and BIOS and removed DPMC information.
Table of contents Table of contents Revisions............................................................................................................................................................................. 2 Table of contents ................................................................................................................................................................ 3 Introduction ................................................................................................
Introduction Introduction This document provides information about the supported software, firmware, and hardware versions and technical specifications for the Dell EMC XC6320 Series Hyper-Converged Appliance. This Support Matrix contains the latest compatibility and interoperability information. If you observe inconsistencies between this information and other documentation or references, this document supersedes all other documentation.
Supported hardware, firmware, and software 1 Supported hardware, firmware, and software This chapter provides information about supported software, firmware, and hardware versions for the Dell EMC XC6320 Series Hyper-Converged Appliance. NOTE: Future updates to this document may remove firmware versions because Nutanix LCM is the prescribed method to update the appliance. 1.
Supported hardware, firmware, and software 1.2 Component v3 Version v4 Version BIOS 1.0.3 and later 2.7.1 or later iDRAC support 2.02.02.02 or later 2.52.52.52 or later Validated BIOS and iDRAC versions Update BIOS and iDRAC using Nutanix LCM. This reference provides the qualified versions of BIOS and iDRAC. These components should be paired. For manual update, the latest version or its predecessor is recommended. This should be a uniform update cluster wide.
Supported hardware, firmware, and software 1.4 Form Factor Capacity Type Vendor 2.5" 200 GB SAS SSD HGST 2.5" 400 GB SAS SSD HGST 2.5" 800 GB SAS SSD HGST 2.5" 800 GB SED SAS SSD HGST 2.5" 1600 GB SED SAS SSD HGST 2.5" 480 GB SATA SSD Samsung 2.5" 960 GB SATA SSD Samsung 2.5" 1920 GB SATA SSD Samsung 2.5" 3840 GB SAS SSD Toshiba 2.5" 1.92 TB SED SAS SSD Toshiba 2.5" 480 GB SATA SSD Intel 2.5" 960 GB SATA SSD Intel 2.5" 1920 GB SATA SSD Intel 2.
Supported hardware, firmware, and software WARNING: Hot plugging an unsupported SFP+ module causes ESXi host to fail with purple diagnostic screen. Call Dell EMC Support to recover from this situation. 1.6 Base networking Base networking Name Firmware version Latest version Intel X520 Dual 10 G BaseT 16.0.24 19.5.12 Supported cables Intel branded SFP+ modules only (10 GbE) Twinax Cable (10 GbE) 1.
Supported hardware, firmware, and software 1.8 Supported hardware management solutions This section provides information about hardware management solutions that are supported by your appliance. Supported hardware management solutions 1.9 Name Minimum version Dell EMC Open Manage Essentials (Monitoring only) 2.0 Dell EMC Nautilus Firmware Update Utility A13 Supported Nutanix AOS software This section provides information about hypervisor release compared to Nutanix AOS release.
Supported hardware, firmware, and software End of Life (EOL) This is defined by the vendor of the operating system. It is recommended to keep a minimum of N-1 with the hypervisor. XC will follow the vendors recommended supported Hypervisor. Supported hypervisor OSs Name Minimum Hypervisor version VMware ESXi 5.5 (EOL) ESXi 6.0 (EOL) ESXi 6.5 or later ESXi 6.7 or later ESXi 7.0 or later ESXi 7.
Supported hardware, firmware, and software Example: 11 Dell EMC XC6320 Series Hyper-Converged Appliance Support Matrix | A23
Technical specifications 2 Technical specifications 2.1 Physical specifications This chapter provides technical specifications for Dell EMC XC6320 Hyper-Converged Appliance. This section provides expansion physical specifications for storage, including height, width, depth, maximum configuration weight and empty weight. Physical specifications 2.2 Physical Specification Height 8.68 cm (3.42 inch) Width 44.8 cm (17.6 in.) Depth 79.0 cm (31.1 in.) Weight (Maximum) 39 kg (86.00 lb) (with 24*2.
Technical specifications 2.4 Type Specification Maximum inrush current Initial Inrush current and secondary inrush current cannot exceed 50A (peak). System battery (per system board) CR 2032 3.0-V lithium ion coin cell Memory specifications This section provides memory specifications for your hardware, including architecture, memory module sockets, and memory module capacities.
Technical specifications Type Specification Relative humidity Storage 5% to 95% RH with 33°C (91°F) maximum dew point. The atmosphere must be noncondensing always. Operating 20%–80% (noncondensing) with a maximum humidity gradation of 10% per hour. Maximum vibration Storage 0.26 Grms at 5 Hz to 350 Hz (all operation orientations). Operating 1.88 Grms at 10 Hz to 500 Hz for 15 min (all six sides tested). Maximum shock Storage One shock pulse in the positive z axis of 31 G for 2.
Documentation Matrix 3 Documentation Matrix The documentation matrix provides information about the documents that you use to configure and deploy the Dell EMC Hyper-Converged Appliance solution. WARNING: See the safety and regulatory information that shipped with your system. Warranty information may be included with this document or as a separate document.
Documentation Matrix 3.2 To learn about... Refer to... Setting up and using Dell EMC iDRAC8 Dell EMC iDRAC8 Quick Start Guide Using OpenManage Essentials to monitor, perform updates, view hardware, and view inventory on your system Dell EMC OpenManage Essentials User's Guide Nutanix documentation Nutanix documentation is found using the Nutanix portal found at https://portal.nutanix.com/#/page/docs. To display a complete set of documentation, you must have user credentials to log in.
Documentation Matrix 17 To learn about... Acropolis base document name Software instructions for hardware components that are not functioning. Hardware Replacement Documentation Comprehensive instructions and references for the Nutanix UI, including overview information. Prism Web Console Guide Monitoring multiple Nutanix cluster through web console.
Contacting Dell EMC 4 Contacting Dell EMC Dell EMC provides several online and telephone-based support and service options. If you do not have an active internet connection, you can find contact information about your purchase invoice, packing slip, bill, or Dell EMC product catalog. Availability varies by country and product, and some services may not be available in your area. To contact Dell EMC for sales, technical assistance, or customer-service issues: 1. Go to Dell.com/support. 2.
Quick Resource Locator 5 19 Quick Resource Locator Use the Quick Resource Locator (QRL) to get immediate access to Dell EMC XC6320 solution information. This information provides access to reference documentation, a link to the Dell EMC support page, and links to hardware-specific QRL pages, which include how-to videos. You can access this information by visiting www.dell.com/QRL or by using your smartphone or tablet and scanning the QR code below.