Dell EMC XC630 Series Hyper-Converged Appliance Support Matrix February 2021 Dell EMC Support Matrix
Revisions Revisions Date Description February 2021 Updated the following sections: • • • • • • Validated BIOS and iDRAC versions Supported HBAs Supported hardware management solutions Supported Nutanix AOS software Supported hypervisor OSs Added the Driver support section December 2020 Updated the Supported management software section.
Table of contents Table of contents Revisions............................................................................................................................................................................. 2 Table of contents ................................................................................................................................................................ 3 Introduction ................................................................................................
Introduction Introduction This document provides information about the supported software, firmware, and hardware versions and technical specifications for the Dell EMC XC630-16G Series Hyper-Converged Appliance. This Support Matrix contains the latest compatibility and interoperability information. If you observe inconsistencies between this information and other documentation or references, this document supersedes all other documentation.
Supported hardware, firmware, and software 1 Supported hardware, firmware, and software This chapter provides information about supported software, firmware, and hardware versions for the Dell EMC XC630 Series Hyper-Converged Appliance. NOTE: Future updates to this document may remove firmware versions because Nutanix LCM is the prescribed method to update the appliance. 1.
Supported hardware, firmware, and software Component v3 Version v4 Version E52698 v4 E52699 v4 E52603 v4 1.2 BIOS 1.2.10 and later 2.7.1 or later iDRAC support 2.02.02.02 or later 2.52.52.52 or later Validated BIOS and iDRAC versions Update BIOS and iDRAC using Nutanix LCM. This reference provides the qualified versions of BIOS and iDRAC. These components should be paired. For manual update, the latest version or its predecessor is recommended. This should be a uniform update cluster wide.
Supported hardware, firmware, and software 1.4 Form Factor Capacity Type Vendor 2.5" 800 GB SED SAS SSD HGST 2.5" 1600 GB SED SAS SSD HGST 2.5" 480 GB SATA SSD Samsung 2.5" 960 GB SATA SSD Samsung 2.5" 1920 GB SATA SSD Samsung 2.5" 3840 GB SAS SSD Toshiba 2.5” 1.92 TB SED SAS SSD Toshiba 2.5" 480 GB SATA SSD Intel 2.5" 960 GB SATA SSD Intel 2.5" 1920 GB SATA SSD Intel 2.
Supported hardware, firmware, and software WARNING: Hot-plugging an unsupported SFP+ module causes ESXi host to fail with purple diagnostic screen. Call Dell EMC Support to recover from this situation. 1.6 1.
Supported hardware, firmware, and software 1.8 Supported Nutanix AOS software This section provides information about hypervisor release compared to Nutanix AOS release. Refer to Nutanix AOS Product support for current releases located here. Supported management software 1.9 Name AOS version AHV 5.1 or later Windows Server 2016 5.5.0.4 or later Windows Server 2019 5.17 or later ESXi 6.5d 5.1 or later ESXi 6.7 (all updates) 5.9 or later ESXi 7.0 Foundation 4.5.4.2 or later AOS 5.
Supported hardware, firmware, and software Supported hypervisor Oss Name 1.10 Minimum version required VMware ESXi 6.0 U3 (EOL date 3/12/2020) ESXi 6.5d, 6.5U1, 6.5U2, 6.5U3 ESXi 6.7, 6.7U1, 6.7U2, 6.7U3 ESXi 7.0, 7.0U1 Windows Server Windows Server 2012 R2 (EOL) Server Windows 2016 with GUI (OEM) Server Windows 2016 with GUI or Core (VL) Windows Server 2019 with GUI or Core (VL) Acropolis Hypervisor (AHV) AHV 5.
Technical specifications 2 Technical specifications 2.1 Physical specifications This chapter provides technical specifications for Dell EMC XC630 Hyper-Converged Appliance. This section provides expansion physical specifications for storage, including height, width, depth, maximum configuration weight and empty weight. Physical specifications 2.2 Physical Specification Weight (Empty) 36.5 kg (80.5 lb.
Technical specifications 2.4 Expansion Bus Specification Riser 3 (Slot 2) One low profile, half-length x8 link or one low profile, half-length x16 link Power specifications This section provides power specifications for your hardware, including wattage, heat dissipation, and voltage. NOTE: This system is also designed to connect to IT power systems with a phase to phase voltage not exceeding 230 V.
Technical specifications Memory Specification LRDIMM 32 GB or 64 GB RDIMM 16 GB or 32 GB Minimum RAM 64 GB Maximum RAM LRDIMM Up to 1.5 TB RDIMM Up to 768 GB RAID controller Controller type 2.6 PERC 9 family Hard drive specification This section provides hard drive specifications for your hardware. Hard drive specification 2.7 Type Specification Ten hard-drive systems Up to ten 2.
Technical specifications 2.8 Video specifications This section provides video specifications for storage, including type, and memory. Video specifications 2.9 Type Specification Video type Integrated VGA controller Video memory 16 MB Environmental specifications This section provides environmental specifications for storage, including temperature, relative humidity, maximum vibrations, particulate contamination, gaseous contamination, and expanded operating temperature.
Technical specifications Type Specification Operating Six consecutively run shock pulses in the positive and negative x, y, and z axes (one pulse on each side of the system) of 71 G for up to 2 ms. Maximum altitude Operating 3,048 m (10,000 ft) Storage 12,000 m (39,370 ft) Operating altitude de-rating Up to 35°C (95°F) Maximum temperature is reduced by 1°C/300 m (1°F/547 ft) above 950 m (3,117 ft).
Technical specifications Type Specification NOTE: Applies to data center and non-data center environments. Gaseous contamination NOTE: Maximum corrosive contaminant levels measured at ≤50% relative humidity. 16 Copper coupon corrosion rate <300 Å/month per Class G1 as defined by ANSI/ISA71.04-1985. Silver coupon corrosion rate <200 Å/month as defined by AHSRAE TC9.9.
Documentation Matrix 3 Documentation Matrix The documentation matrix provides information about the documents that you use to configure and deploy the Dell EMC Hyper-Converged Appliance solution. WARNING: See the safety and regulatory information that shipped with your system. Warranty information may be included with this document or as a separate document.
Documentation Matrix 3.2 To learn about... Refer to... How to install your system in to a rack Dell Rack Install Guide How to deploy and set up this solution Solutions Guide Setting up and using Dell EMC iDRAC8 Dell EMC iDRAC8 Quick Start Guide Using OpenManage Essentials to monitor, perform updates, view hardware, and view inventory on your system Dell EMC OpenManage Essentials User's Guide Nutanix documentation Nutanix documentation is found using the Nutanix portal found at https://portal.
Documentation Matrix 19 To learn about... Acropolis base document name Software instructions for hardware components that are not functioning. AHV Administration Guide Software instructions for hardware components that are not functioning. Hardware Replacement Documentation Comprehensive instructions and references for the Nutanix UI, including overview information. Prism Web Console Guide Monitoring multiple Nutanix cluster through web console.
Contacting Dell EMC 4 Contacting Dell EMC Dell EMC provides several online and telephone-based support and service options. If you do not have an active internet connection, you can find contact information about your purchase invoice, packing slip, bill, or Dell EMC product catalog. Availability varies by country and product, and some services may not be available in your area. To contact Dell EMC for sales, technical assistance, or customer-service issues: 1. Go to Dell.com/support. 2.
Quick Resource Locator 5 21 Quick Resource Locator Use the Quick Resource Locator (QRL) to get immediate access to Dell EMC XC630 solution information. This information provides access to reference documentation, a link to the Dell EMC support page, and links to hardware-specific QRL pages, which include how-to videos. You can access this information by visiting www.dell.com/QRL or by using your smartphone or tablet and scanning the QR code below.