PCoIP Zero Client Firmware Version 5.5.1 Release Notes Current Version: 5.5.1 Release Date: 2017-10 Previous Version: 5.4.1 Copyright © 2017 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries. Other trademarks may be trademarks of their respective owners.
Contents Release type and definition ............................................................................................................ 3 Current Version ................................................................................................................................ 3 Previous version .............................................................................................................................. 3 What’s new in this release ............................................
Release type and definition PCoIP Zero Client Firmware v5.5.1 is a firmware for Tera2 PCoIP Zero Clients and not for PCoIP Remote Workstation Cards. This release is a feature release with functional changes and bug fixes over release 5.4.1. These release notes provide a summary of key feature additions, compatibility notes, resolved issues, and known issues for this release. Current Version 5.5.1 Previous version 5.4.
Important notes Wyse Device Manager Wyse Device Manager v5.7.2 and v5.7.1 support 4.x, 5.2.2, 5.4.1, and 5.5.1 versions of firmware. Earlier versions of Wyse Device Manager support only 4.x. If you are using earlier versions of Wyse Device Manager, then upgrade the Wyse Device Manager to version 5.7.1, and proceed with the firmware update. Teradici console PCoIP Management Console v2.x cannot detect or manage devices on firmware versions prior to v5.0. If you upgrade from firmware v4.
Support matrix Compatibility Notes Workstation This release is compatible with VMware Horizon 7.1. It is also compatible with one major release of Horizon prior to this. Other versions of Horizon may also be compatible, but will need to be verified in your specific deployment environment. VMware Horizon Amazon WorkSpaces Teradici Cloud Access Platform ✔ PCoIP Connection Manager for Amazon WorkSpaces 1.0.2 or higher is required in order to connect to Amazon WorkSpaces.
changed to PCoIP Connection Manager, with the address of the Leostream Connection Broker. Also ensure the Leostream Connection Broker has had ‘Enable TLSv1.1 protocol’ enabled in the Connection Broker Security Options section of the Connection Broker > System > Settings page. Supported browsers are Firefox, Chrome, Internet Explorer 11, and Microsoft Edge. Versions of the browsers tested are those that were available prior to release. Web browsers must support TLS 1.
Workaround: On Tera2 Zero Clients, bridge the KM and enable the Force Local Cursor Visible on the zero client Configuration > USB Administrative Web Interface. Zero client fails to resolve FQDN with a label that starts or ends with an underscore A zero client will not resolve an FQDN that begins or ends with the underscore character (for example, _myhost.teradici.local).
3. Insert the smart card. Windows 7 should recognize the smart card and reader and automatically install the correct drivers. 4. Log off Windows to disconnect the session. 5. From the zero client administrative web interface, remove the bridge configuration for the smart card reader. 6. Log in with the smart card. The smart card should be fully accessible.
Increased smart card transaction timeout The zero client smart card remoting feature's idle timeout has been increased from five to 20 seconds to improve compatibility with versions of Windows older than Windows 8. Zero client event log flooded with messages in 802.1x and PoE environments The zero client event log may have become flooded with messages that began with "RDMA2 :src_mac" when the zero client is operating in PoE (Power over Ethernet) mode or is configured to use 802.1x. This is now resolved.