Deployment Guide
Integrating Dell Networking W-AirWave 8.0 with Centralized
NMS Event Correlation
Overview
This document describes the AirWave alert/trap workflow when integrating with a centralized NMS Event Correlation
System. This document includes the following topics:
l "Adding NMS Event Correlation Servers to AirWave" on page 1
l "Configuring Alerts/Traps in AirWave" on page 2
l "Viewing Alerts in Various Destinations" on page 3
l "Acknowledging Alerts" on page 5
l "Compiling the AirWave MIB on NMS" on page 5
l "Matching Severity in the NMS Event Correlation Servers" on page 5
l "MIB for SNMPv2c" on page 6
Adding NMS Event Correlation Servers to AirWave
Perform the following steps to add an event correlation server to AirWave.
1. Navigate to AMP Setup > NMS and click Add.
2. Configure server settings. The configuration options can vary depending on the SNMP version that you select.
Ifyou select SNMPv3, then you must also configure your application (i.e the application that will receive the traps/informs)
for SNMPv3. You will need to set up the engineID, authentication, and Priv parameters and then restart your application
before you can receive the SNMPv3 informs.
Figure 1:AMP Setup > NMS > Add NMSServer Page Illustration
Integrating W-AirWave with Centralized NMSEvent Correlation | Integration 0511042-05 | May 2014