Setup Guide

Dell Networking SPR-RK3-MNT
Installation Guide
0511709-02 | April 2015 1
This document provides installation instructions for standard front-rack mounting the Dell W-7024/W-7205
controller in a standard two-post 19" Telco rack using the SPR-RK3-MNT accessory kit.
The W-7024/W-7205 controller is referred to as "device” in rest of the document.
Package Contents
 Two rack mount brackets
 Eight M4 x 8 mm Phillips Flat Head screws
 Four M6 x 15 mm Phillips Pan Head screws
 Four M6 cage nuts
 Four M6 clip nuts
 Installation Guide (this document, printed)
Standard Rack Mount Installation
This option allows mounting the device from the front in a standard two-post 19” Telco rack.
Required Tools and Equipment
 Two rack-mount brackets
 Eight M4 x 8 mm Phillips Flat Head screws
 Four M6 x 15 mm Phillips Pan Head screws
 Four M6 cage nuts (optional)
 Four M6 clip nuts (optional)
 Suitable screwdrivers (not included in this kit)
Installation Steps
To install the device in a two-point 19” (48.26 cm) rack system:
1. Place the mounting brackets over the mounting holes near the front on either sides of the device (see Figure
1).
NOTE: Some racks require screws that differ from those included with the device. Confirm that you have the correct screws
before installing the device.
CAUTION: Each device should have its own mounting equipment. Do not place other networking equipment directly on top of a
mounted device. Failure to do so can result in damage to the device.
NOTE: The figures in this document illustrate the installation procedure for the W-7205 controller. The same installation procedure
applies to the W-7024 controller.