Installation manual

620 Desk Stand Kit

Installation Guide

0510692-02 | July 2010 1

The 620 Desk Stand allows you to install your 620 controller vertically, reducing the amount of space it

occupies.

This kit includes:

z 1x Stand

z 1x Base

z 1x Lock

z 4x T10 Torx screws

z 1x T15 Torx screw

Installation

1. Attach the base to the stand as shown in Figure 1.

a. Align the posts on the stand with corresponding holes in the base.

b. Secure the stand to the base using the four T10 Torx screws provided in this kit.

Figure 1 Attaching the Base to the Stand

PAGE 1
620 Desk Stand Kit Installation Guide The 620 Desk Stand allows you to install your 620 controller vertically, reducing the amount of space it occupies. This kit includes: z 1x Stand z 1x Base z 1x Lock z 4x T10 Torx screws z 1x T15 Torx screw Installation 1. Attach the base to the stand as shown in Figure 1. a. Align the posts on the stand with corresponding holes in the base. b. Secure the stand to the base using the four T10 Torx screws provided in this kit.
PAGE 2
. Orient the controller as it is shown in Figure 2. 3. Insert the controller into the desk stand.
PAGE 3
4. Complete the installation by securing the controller to the stand as shown in Figure 3. a. Insert the lock into the opening in the right side of the stand. b. Insert the T15 Torx screw into the lock and tighten it until secure. Figure 3 Securing the Controller 5. Complete the installation by connecting all the necessary cables.