White Papers

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4148U-ON

Dell EMC Technical White Paper

Dell EMC Networking – Deploying Native FC and

FCoE on single S4148U-ON

Short guide on deploying Fibre-Channel and Fibre-Channel over

Ethernet using the Dell EMC S4148U-ON

Abstract

A short configuration guide on FC and FCoE using the Dell EMC

S4148U-ON simultaneously

May 2018

Summary of content (7 pages)

PAGE 1
Dell EMC Networking – Deploying Native FC and FCoE on single S4148U-ON Short guide on deploying Fibre-Channel and Fibre-Channel over Ethernet using the Dell EMC S4148U-ON Abstract A short configuration guide on FC and FCoE using the Dell EMC S4148U-ON simultaneously May 2018 Dell EMC Technical White Paper
PAGE 2
Revisions Revisions Date Description May 2018 Initial release Acknowledgements This paper was produced by the following members of the Dell EMC technical marketing engineering team: Author: Mario Chow Support: Other: The information in this publication is provided “as is.” Dell Inc. makes no representations or warranties of any kind with respect to the information in this publication, and specifically disclaims implied warranties of merchantability or fitness for a particular purpose.
PAGE 3
Acknowledgements Table of contents Revisions.............................................................................................................................................................................2 Acknowledgements .............................................................................................................................................................2 Test Set Up ........................................................................................................
PAGE 4
S4148U-ON Configuration Details Test Set Up Figure 1 shows the setup used to test native Fibre-Channel (FC) and Fibre-Channel over Ethernet (FCoE) deployment on the Dell EMC S4148U. The following list defines the setup:       Traffic is uni-directional Storage traffic is generated by the server The S4148U is running OS10 (10.4.
PAGE 5
S4148-ON Configuration Details A S4148-ON Configuration Details Fibre-Channel Configuration 1. Enable FC feature and a domain ID for FPort a. Switch# conf t b. Switch(config)# dcbx enable c. Switch(config)# feature fc 2. Configure the Ethernet interface as fibre-channel interface a. Switch# conf t b. Switch(config)# port-group 1/1/1 c. Switch(conf-pg-1/1/1)# mode fc <16g-2x or 8g-4x> d. Switch(conf-pg-1/1/1)# end e. Switch# 3. Create FCoE vlan a. Switch# conf t b.
PAGE 6
Acknowledgements Fibre-Channel over Ethernet Configuration 6. The configurations from steps 1-5 apply for straight native Fibre-channel deployment on the S4148U. The subsequent configuration steps apply to Fibre-channel over Ethernet deployment. a. Switch# conf t b. Switch(config)# policy-map type qos test c. Switch(config-pmap-qos)# class class-trust d. Switch(config-pmap-qos)# trust dot1p e. Switch(config-pmap-qos)# end f. Switch# 7.
PAGE 7
S4148-ON Configuration Details h. Switch(config-pmap-c-que)# end i. Switch# 11. Configure the service policy maps and qos maps on all the relevant interfaces expected to receive LAN and SAN traffic. In this case, there is only one interface that is expected to receive LAN and FCoE traffic. a. Switch# conf t b. Switch(config)# int eth1/1/53 c. Switch(config-eth1/1/53)# description Link_2_CNA_FCoE d. Switch(config-eth1/1/53)# switchport mode trunk e. Switch(config-eth1/1/53)# switchport access vlan 1 f.