Setting Up Dell EMC PowerEdge Server Using Lifecycle Controller May 2021 Rev.
1 Topics: • Setting Up Dell EMC PowerEdge Server Using Lifecycle Controller Setting Up Dell EMC PowerEdge Server Using Lifecycle Controller 1. Open Lifecycle Controller. a. Power on the server and press F10 to open Lifecycle Controller. NOTE: Accessing Lifecycle Controller by pressing F10 is not applicable for BMC users. NOTE: If you miss pressing F10, restart the server and press F10. The Initial Setup Wizard is displayed only when you open Lifecycle Controller for the first time. 2.
iDRAC Service Module You can install iDRAC Service Module using: iDRAC Express or iDRAC Enterprise. Installing iDRAC Service Module from iDRAC Express 1. From the iDRAC Settings page, select iDRAC Service Module Setup page, click Install Service Module. The Service Module installer is available to the host operating system and a job is created in iDRAC. 2. To locate the Service Module installer file, log in to the server either remotely or locally. 3.
Copyright © 2019 - 2021 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries. Other trademarks may be trademarks of their respective owners.
