Dell EMC PowerEdge C4140 Technical Specifications Regulatory Model: E53S Series Regulatory Type: E53S001 Dec 2020 Rev.
Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. © 2019- 2020 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries.
Contents Chapter 1: Technical specifications............................................................................................... 4 Chassis dimensions..............................................................................................................................................................5 System weight......................................................................................................................................................................
1 Technical specifications The technical and environmental specifications of your system are outlined in this section. NOTE: Internal cable connectors are not hot-pluggable.
Chassis dimensions Figure 1. Details the dimensions of PowerEdge C4140 system Table 1. The dimensions of PowerEdge C4140 system Xa Xb Y Za Zb* Zc 482.4 mm (18.99 inches) 434 mm (17.08 inches) 43.1 mm (1.69 inches) 18.0 mm (0.70 inches) 886.4 mm (34.89 inches) 923.8 mm (36.37 inches) * - Zb goes to the nominal rear wall external surface where the system board I/O connectors are located. System weight Table 2.
● NVIDIA Tesla V100 16 GB PCIe and NVLink ● NVIDIA Tesla V100 32GB PCIe and NVLINK Processor specifications The PowerEdge C4140 system supports two 2nd Generation Intel Xeon Scalable processors with up to 26 cores per processor. NOTE: Ensure that both the processors are populated and both are of same type or model. NOTE: Processor sockets are not hot-pluggable.
Table 4. Dell EMC PowerEdge C4140 fan support matrix Processor count Fan 1 Fan 2 Fan 3 Fan 4 Fan 5 Fan 6 Fan 7 Fan 8 2 Required Required Required Required Required Required Required Required NOTE: Each fan is listed in the systems management software, referenced by the respective fan number. If there is a problem with a particular fan, you can easily identify and replace the proper fan by noting the fan numbers on the cooling fan assembly.
NOTE: The M.2 boot drives have to be of the same capacity and set in a mirrored RAID-1 configuration. NOTE: Initial status LED of PCIe SSDs may vary based on the actual drive status and server components populated. NOTE: IDSDM and vFlash slot is not hot-pluggable NOTE: Mini-PERC socket is not hot-pluggable. Drive specifications The Dell EMC PowerEdge C4140 system supports optional two 2.5-inch cabled SATA SSDs is installed only in PSU 2 bay.
Serial port The PowerEdge C4140 system supports one serial port on the rear view. This port is a 9-pin connector, Data Terminal Equipment (DTE), 16550-compliant. NOTE: The serial port is not hot-pluggable. VGA ports The Video Graphic Array (VGA) port enables you to connect the system to a VGA display. The PowerEdge C4140 system supports one 15-pin VGA port on the back of system. NOTE: The VGA ports are not hot-pluggable.
Table 9. Relative humidity specifications Relative humidity Specifications Storage 5% to 95% RH with 33°C (91°F) maximum dew point. Atmosphere must be non-condensing at all times. Operating 10% to 80% relative humidity with 29°C (84.2°F) maximum dew point. Table 10. Maximum vibration specifications Maximum vibration Specifications Operating 0.26 G rms at 5 Hz to 350 Hz (all operation orientations). Storage 1.88 G rms at 10 Hz to 500 Hz for 15 min (all six sides tested). Table 11.
Table 15. Configuration B (continued) CPU Power Dissipation / GPU Power (4x) 2x 70 W 2x 85 W 2x 105 W 2x 125 W 2x 130 W 2x 140 W 2x 150 W 2x 165 W 250 W 27 26 26 25 25 24 23 22 225 W 29 28 28 27 27 26 25 24 200 W 30 30 30 30 29 28 27 26 Table 16.
Table 20. Particulate contamination specifications Particulate contamination Specifications Air filtration Data center air filtration as defined by ISO Class 8 per ISO 14644-1 with a 95% upper confidence limit. NOTE: This condition applies to data center environments only. Air filtration requirements do not apply to IT equipment designed to be used outside a data center, in environments such as an office or factory floor. NOTE: Air entering the data center must have the MERV11 or MERV13 filtration.
