Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide Dell Business Client Re-Image “How-To” Guide Latitude Tablet and 2-in-1 System Revision 1.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide Contents 1 Overview .............................................................................................................................................................................. 3 2 “How-To” ............................................................................................................................................................................. 3 3 2.1 Supported Operating Systems .........................
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide 1 Overview The purpose of this document is for reimaging Dell Latitude Tablet. These images include the Dell recommended software stack and settings, drivers, and applications which are tested and validated with the system. Drivers and applications must be installed on Dell Latitude Tablet in a prescribed order to ensure optimal performance. Failure to install drivers and applications in this document may result in undesirable performance.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide These drivers are required to enable the features of the Dell Latitude 5175/5179/7275 and Dell XPS 9250. The needed drivers and their supporting applications can be retrieved from the following URLs: Latitude 5175: http://www.dell.com/support/home/us/en/04/product-support/product/latitude-5175-laptop/drivers Latitude 5179: http://www.dell.com/support/home/us/en/04/product-support/product/latitude-5179-laptop/drivers Latitude 7275: http://www.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide 2.4 BIOS Dell recommends flashing the latest BIOS available to system. This is posted on Dell’s driver & downloads support web site (dell.com/support) under the “BIOS” section. Some of the BIOS settings are critical to Operating System performance and installation. These are recommended settings as follows: 1. POST Behavior-> Fastboot->Thorough The system USB configuration must be set to allow for USB boot.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide For Latitude 7275/XPS 9250, we recommended to additional enable Thunderbolt Boot Support for TypeC USB Dock device. System Configuration->USB/Thunderbolt Configuration->Enable Thunderbolt Boot Support. The Type-C device will be identified and boot to external device via Type-C. 2. In order to boot to PXE from an Ethernet network device, the UEFI network stack must be enabled.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide 3 OS 3.1 Two basic methods to install OS image 1. Hand install from UEFI bootable USB flash drive that contains the OS install files. 2. Automated image install/deployment through Enterprise solutions such as Microsoft’s SCCM. 3.1.2 Hand Install through USB Flash Drive Microsoft™ has made is easier than ever to create USB flash drive install media. Just download the “Media Creation Tool” (MCT) available from these URLs for the desired OS.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide 3. Select “Language, Edition and Architecture”.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide 4. The MCT can create an ISO image or prepare a USB flash drive to boot the installer. Select “USB flash drive” and click next.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide 5. The MCT will show a list of USB flash drives that it has detected, select the drive to be used as the install device from the list and click next. It is recommended that the USB flash drive have storage space of 4GB or greater. The MCT will download the Windows 10 install files and create a bootable USB flash drive. The process will take several minutes.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide 6. When the MCT has completed, select Finish. The USB flash drive is now ready to boot the Windows 10 installer.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide 3.1.2.1.2 Windows 8.1 – USB install media creation Download the Windows 8.1 MCT to any workstation running Windows 7 or higher. Run the tool as admin and follow the prompts. 1. When 1st run, the tool prompts for selection of Language, OS edition and Architecture. Select the required settings and then click next. The rest of the process is similar to the process previously outlined for Windows 10.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide Dell recommends always obtaining the latest and most updated drivers, firmware, and applications on Dell’s support web site http://www.dell.com/support For best results, Dell recommends installing drivers / applications one by one - by following driver sequence in below table Latitude 5175 Systems Latitude Latitude 5179 7275 XPS 9250 Sub Function Category Intel Chipset Device Software Intel(R) USB 3.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide Intel(R) Thunderbolt(TM) 3 Firmware Update 3 Realtek USB GBE Ethernet Controller Driver for Dell Thunderbolt Dock and Dell Dock 3 Realtek USB Audio Driver for Dell Wireless Dock, Dell Thunderbolt Dock, and Dell Dock 3 Update for the USB audio/mouse on Dell Thunderbolt Dock and Dell Dock 3 ASMedia USB 3.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide Driver Pack Dell Command | Monitor Dell Command | Deploy Driver Pack Dell Command | Update Dell Command | Intel® vPro™ Out of Band Dell Command | Integration Suite for System Center 2012 Management Systems Management Systems Management Systems Management Systems Management Systems Management O O O O O O O O O O O O X X O O X X O O 1.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide As soon as the Dell splash screen is displayed, press the F12 to bring up the one-time boot selection menu. For this example, the Dell Dock TB15 was used in conjunction with a Latitude 7275. The process for the XPS 9250/Latutude 5179/5175 would be similar. After pressing enter, the system will then boot to the USB flash drive and start the OS installer. Follow the OS installer prompts to complete the OS install process.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide image file must have the drivers installed for the Latitude/XPS system’s network device. Latitude and XPS can boot both standard PXE DOS (initrd) and EUFI images; dependent on BIOS boot mode and USB to Ethernet adapters. Support PXE network booting for connection to automated install and deployment servers. It is recommended to use the network capabilities of the docking unit to provide PXE boot and network support for the system.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide If the network topology is IPv4: Use the keyboard arrow keys or the system’s Volume-Up button to highlight, “Onboard NIC (IPv4)” then press Enter or press the Volume-Down button on the tablet. If the network topology is IPv6: Use the keyboard arrow keys or the system’s Volume-Up button to highlight, “Onboard NIC (IPv6)” then press Enter or press the Volume-Down button on the system.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide Latitude 5175/5179/7250 and XPS 9250 have PXE code included in the UEFI BIOS that can boot the following USB-C network devices. USB-C/Thunderbolt to Ethernet Controller Dell P/N: D59GG (USB-C to Gigabit Ethernet) Dell P/N: 5FDDV (Dell Dock WD15) Dell P/N: J00G9 (Dell Dock TB15) 4.1.3 Device Drivers / Apps Dell provides pre-packaged driver and app Cab files for OS deployment through SCCM or other deployment services.
Dell Latitude Tablet and 2-in-1 System Reimage “How-To” Guide 4.1.3.1 SCCM System Drive Partition Setup Follow Microsoft’s recommended drive partition guidelines for UEFI based systems located at this URL, https://msdn.microsoft.com/en-us/library/windows/hardware/dn898510(v=vs.85).aspx The guideline includes a “Diskpart” script example for creating the required OS partitions. More information with respect to capturing and applying Windows, System, and Recovery Partitions can be found here: https://msdn.
