Dell EMC OEM Identity Module Installation Guide using iDRAC Web Interface A document to describe the process of installing an Identity Module on a Dell EMC server using iDRAC web interface.
Revisions Date Description June 2018 Initial release The information in this publication is provided “as is.” Dell Inc. makes no representations or warranties of any kind with respect to the information in this publication, and specifically disclaims implied warranties of merchantability or fitness for a particular purpose. Use, copying, and distribution of any software described in this publication requires an applicable software license. Copyright © 2018 Dell Inc. or its subsidiaries.
Table of contents Revisions.............................................................................................................................................................................2 3 1 Introduction ...................................................................................................................................................................4 2 Prerequisites............................................................................................................
1 Introduction The Dell EMC OEM Identity Module enables OEMs to rebrand and customize their products. The Identity module centralizes the control points of multiple features, enabling OEM customers to save time and resources when deploying their systems.
3 Installing Identity Module The procedure to install the Identity Module is as follows: 1. Upload and install the Identity Module file. 2. Reset the iDRAC. 3. Set BIOS to defaults. 3.1 Uploading and installing Identity Module file 1. Log in to the iDRAC web interface using a web browser. The link for the iDRAC web interface is http://. 2. Navigate to the following page: - iDRAC 9: Click Maintenance System Update. - iDRAC 8/7: In the left navigation pane, click Update and Rollback. 3.
3.3 Setting BIOS to defaults 1. 2. 3. 4. 5. 6. 7. 8. 4 Access System Setup on the host system by pressing F2 during POST. On the System Setup page, click System BIOS. In the bottom-left corner, click Default. Accept all the message to load the BIOS defaults. In the lower-right corner, click Finish. Accept all the messages to save the changes and return to the System Setup page. On the System Setup page, click Finish. Accept all messages to exit System Setup and reboot the system.
