Dell EMC ME4 Series ME412 and ME424 Expansion Enclosures Getting Started Guide Regulatory Model: E09J, E10J Regulatory Type: E09J001, E10J001 August 2018 Rev.
Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. © 2018 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries.
Contents Chapter 1: Setting up the ME4 Series expansion enclosure............................................................ 4 Chapter 2: Other information you may need.................................................................................. 5 Chapter 3: Installation safety precautions..................................................................................... 6 Chapter 4: NOM information .....................................................................................................
1 Setting up the ME4 Series expansion enclosure Consider the following best practices when setting up an ME4 Series expansion enclosure. ● Before connecting any cables between the storage system and the host server or expansion enclosure, physically label each port and connector. ● Always follow proper power-up and power-down procedures when cycling power across the network. Verify that critical network components are on separate power circuits.
2 Other information you may need To install the storage system, you may need the following additional information: NOTE: See the Enterprise Products Safety, Environmental, and Regulatory Information that shipped with your storage system. Warranty information is included as a separate document. ● The ME4 Series Storage System Deployment Guide provides information about cabling storage system hardware components and configuring a new storage system.
3 Installation safety precautions Always follow these safety precautions to avoid injury and damage to storage system equipment. If equipment described in this guide is used in a manner not specified by the documentation, the protection provided by the equipment could be impaired. For your safety and protection, observe the rules described in the following sections. Follow these safety precautions: ● It is recommended that only individuals with rack-mounting experience install the system in a rack.
4 NOM information The following information is provided on the device described in this document in compliance with the requirements of the official Mexican standards (NOM): NOM information Importer Dell México, S.A. de C.V Av. Javier Barros Sierra, no 540, Piso 10, Col. Lomas de Santa Fe Delegación Álvaro Obregón, Ciudad de México C.P. 01219 R.F.C: DME9204099R6 Model numbers E09J, E10J Supply voltage 100–240 VAC Frequency 50/60 Hz Current consumption 8.0-3.
5 Technical specifications AC power supply specifications Maximum output power 580 W Maximum input power 687 W Maximum input current 8.8 A Maximum inrush current 20 A Nominal input voltage operating range 100-240 VAC Nominal input frequency 50/60 Hz Physical characteristics Height 87.9 mm (3.46 in) Width across mounting flange 483 mm (19.01 in) Width across enclosure body 443 mm (14.44 in) Depth from face of mounting flange to back 576.8 mm (22.