User's Manual
OEM Installation Guidance
For Dell RFID 13.56MHz Wireless Module
FCC ID: E2K‐DWRFID1802
IC: 1514B-DWRFID1802
‐ OEM integrators must ensure that its product is electrically identical to Dell’s reference
designs. Any modifications to Dell’s reference designs may invalidate regulatory approvals in
relation to the product, or may necessitate notifications to the relevant regulatory
authorities.
‐ OEM integrators are responsible for regression testing to accommodate changes to
designs, new antennas, and host and submit for C2PC filings.
Colocation with other transmitter modules will be addressed through filings for those co‐
located transmitters when necessary or that colocation of other transmitters will be
according to applicable KDB guidelines including those for RF exposure
‐ The final system integrator must ensure there is no instruction provided in the user
manual or customer documentation indicating how to install or remove the transmitter
‐ Appropriate labels must be affixed to the product that complies with applicable
regulations in all respects. The regulatory label on the final system must include the
statement: “Contains FCC ID: E2K‐DWRFID1802 and/or IC: 1514B-DWRFID1802”.
‐ A user’s manual or instruction manual must be included with the product that contains
the text as required by applicable law shall be provided to OEM integrators. They may
include:
1. USA—Federal Communications Commission (FCC)
FCC COMPLIANCE STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
INFORMATION TO USER:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by tuning the equipment off and on, the user
is encouraged to try and correct the interference by one or more of the following measures:
‐ Reorient or relocate the receiving antenna
‐ Increase the distance between the equipment and the receiver.
‐ Connect the equipment to outlet on a circuit different from that to which the receiver
is connected.
‐ Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
The final host manual shall include the following regulatory statement: