Specifications

ManualsBrandsDELL ManualsSecurity EquipmentCAC/PIV Smart Card Reader

CAC/PIV Module 3 Manual

Key Characteristic

USB signal input

Support contactless card utilizes NFC technology

Support contact card utilizes card reader

Introduction

This module provides a method to enable security access to the system or

applications via an access card/badge. This module design is taken the chip BCM

BC58202 as main controlled chip. And can support contactless card by NFC

technology and contact card by card reader.

Module fits in slim line ODD form factor. Module include the USH PCBA, contact

reader and NFC antenna.

Summary of content (4 pages)

PAGE 1
CAC/PIV Module 3 Manual Key Characteristic USB signal input Support contactless card utilizes NFC technology Support contact card utilizes card reader Introduction This module provides a method to enable security access to the system or applications via an access card/badge. This module design is taken the chip BCM BC58202 as main controlled chip. And can support contactless card by NFC technology and contact card by card reader. Module fits in slim line ODD form factor.
PAGE 2
Dimension (millimeter) Specification Hardware The input signal is standard USB signal from host system to the main chip BC58202, And the contactless and contact card reader function is achieved through that main chip.
PAGE 3
FCC: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 4
causer d’interférences et (2) cet appareil doit accepter toute interférence, y compris les interférences pouvant provoquer un fonctionnement indésirable de l’appareil. Exposure to Radio Frequency Radiation: Cet équipement est conforme aux limites d'exposition aux rayonnements IC définies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le radiateur et votre corps.