Dell™ SC200/SC220 Storage Enclosures Getting Started With Your System Regulatory Model E03J Regulatory Model E04J
Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your Storage Center. CAUTION: A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. Contacting Dell Technical Support Services For technical support, go to support.dell.com/compellent/.
Installation and Configuration WARNING: Before performing the following procedure, review the safety instructions that came with all Storage Center components. Unpacking the System NOTE: Unpacking, installing, and deploying your Storage Center may be done only by a certified service technician. Before you begin, make sure the site where you intend to set up and use the Storage Center has the following: • Standard power from an independent source or a rack power distribution unit with a UPS.
• Always load the rack from the bottom up for weight stability. • You can allow room for expansion if you have fewer than the maximum number of enclosures. 8 Unwrap and insert each drive into the enclosure one at a time. • Protect the drive from static discharge. • Handle drives by the edges of the frame. CAUTION: If the enclosure system operates for more than a few minutes with missing drives, the enclosure can overheat, causing power failure and data loss. Such use may invalidate the warranty.
Connecting the Power Cables 1 Ensure that the power switch is in the OFF position before connecting the power cables. 2 Connect the enclosure power cables to the rack power. Securing the Power Cables 1 Bend the power cables as shown in the illustration and secure the cables firmly to the bracket using the strap provided.
2 Plug the other end of the power cables into a grounded electrical outlet or a separate power source such as an uninterrupted power supply (UPS) or a power distribution unit (PDU). Location of Power Button NOTE: Do not power up the enclosure until all Storage Center components are racked and cabled. Installing the Optional Bezel • 6 Install the bezel (optional).
Other Information You May Need WARNING: See the safety and regulatory information that shipped with your Storage Center components. Warranty information may be included within this document or as a separate document. • The rack documentation included with your rack solution describes how to install your system into a rack. • The Storage Center Connectivity Guide provides information about cabling all Storage Center hardware components.
NOM Information (Mexico Only) The following information is provided on the device described in this document in compliance with the requirements of the official Mexican standards (NOM): Importer: Model number: Supply voltage: Frequency: Current consumption: Dell Inc. de México, S.A. de C.V Paseo de la Reforma 2620-11 ° Piso Col. Lomas Atlas 11950 México, D.F. E04J 100–240 V CA 50/60 Hz 8.6 A Technical Specifications Drives SAS hard drives SC200: Up to 12 3.5-inch SAS hot-swappable hard drives (6.
Redundant Array of Independent Disks (RAID) (continued) Management RAID management using Storage Center System Manager version 6.
LED Indicators (continued) Power supply/cooling fan Three LED status indicators for power supply status, power supply/cooling fan fault status, and AC status Power Supplies AC power supply (per power supply) Wattage 700 W Voltage 100–240 VAC (8.6 A–4.
Physical (continued) Weight (maximum configuration) SC200: 29.2 kg (64 lb) SC220: 24 kg (53 lb) Weight (empty) SC200: 8.84 kg (19.5 lb) SC220: 8.61 kg (19 lb) Environmental NOTE: For additional information about environmental measurements for specific system configurations, see dell.com/environmental_datasheets.
Environmental (continued) Storage • Half-sine shock 71G +/- 5% with a pulse duration of 2ms +/- 10% (all sides) • Square wave shock 27G with a velocity change of 235 in/sec (all sides) Altitude Operating –16 to 3048 m (–50 to 10,000 ft) NOTE: For altitudes above 2950 feet, the maximum operating temperature is derated 1ºF/550 ft. Storage –16 to 10,600 m (–50 to 35,000 ft) Airborne Contaminant Level Class 12 G2 or lower as defined by ISA-S71.
w w w. d e l l . c o m | s u p p o r t . d e ll .