Dell Chassis Management Controller Version 5.
Release Notes Dell Chassis Management Controller The Dell Chassis Management Controller (CMC) is a hot-pluggable systems management hardware and software solution designed to provide the following functions for Dell PowerEdge M1000e chassis system: • Remote management capabilities • Power control • Cooling control Version Dell Chassis Management Controller 5.20 Release Date October 2016 Previous Version Dell Chassis Management Controller Version 5.
• Dell EqualLogic PS-M4110 What is Supported? Supported Web Browsers CMC version 5.20 is supported on the following Web browsers: • Microsoft Internet Explorer 9 • Microsoft Internet Explorer 10 • Microsoft Internet Explorer 11 • Microsoft EDGE • Safari version 7.1 • Safari version 8.
Release 5.12 • Quick link to the Dell Tech Center page from the CMC web GUI. Release 5.10 • Firmware and driver refresh of COMMs cards on Dell's 13th generation of PowerEdge servers. • Capture and replicate chassis configurations through XML based on the Chassis configuration profile. • Support for blinking server identification LED from Quick Link on the Homepage. • Backup or restore through XML based on the chassis configuration profile.
Release 5.10 • Fixed an issue with the "getmacaddress -c all” command displaying partial IO Identity values for the Intel Dual Port Network Card 10 GBE. • Fixed an issue with the “getmacaddress –m server-x –t iscsi” command displaying non-iSCSI MAC addresses after using the iSCSI filter. • Fixed an issue with flash media features displaying invalid media for active controllers after restoring the chassis. Release 5.02 • Fixed an issue causing CMC redundancy loss in CMC 5.0.
Versions/Systems Affected All CMC versions including CMC 5.20 and PowerEdge servers with iDRAC7 or earlier. Issue 2: Description An error occurs while importing CMC configuration file using local racadm or remote racadm. Resolution This issue occurs when IPv6 is enabled or disabled from the configuration file. Enable or disable IPv6 using the command, “racadm config -g cfgIPv6LanNetworking -o cfgIPv6Enable 0”. Versions/Systems Affected CMC version 5.
Issue 3: Description: When the M1000e chassis is power cycled, the Dell PowerEdge PS-M4110 may not turn on and the message, "iDRAC Not Ready", is displayed. Resolution: To turn on the server, reset CMC or virtually reseat the server. Versions/Systems Affected All CMC versions including CMC 5.20 Installation Prerequisites For information on pre-requisites, see the Dell PowerEdge M1000e Chassis Management Controller Firmware Version 5.20 User's Guide.
4. Select the appropriate service or support link based on your need. Accessing Documents from Dell Support Site To access the documents from Dell Support site: 1. Go to dell.com/support/manuals. 2. In the Tell us about your Dell system section, under No, select Choose from a list of all Dell products and click Continue. 3. In the Select your product type section, click Software and Security. 4.