53-1001804-01 January 31, 2010 Blower Assembly Replacement Procedure Supporting PowerConnect B-DCX4S Backbone and PowerConnect B-DCX Backbone 53-1001804-01 *53-1001804-01*
Notes, Cautions, and Warnings NOTE A NOTE indicates important information that helps you make better use of your computer. CAUTION See the safety and regulatory information that shipped with your system. For additional regulatory information, see the Regulatory Compliance Homepage on www.dell.com at the following location: www.dell.com/regulatory_compliance. CAUTION A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed.
In this guide • Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . • Time and items required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . • Removing a blower assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . • Replacing a blower assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
FIGURE 1 DCX blower assembly ‘ FIGURE 2 4 DCX-4S blower assembly Blower Assembly Replacement Procedure 53-1001804-01
Replacing a blower assembly To replace a blower assembly 1. Orient the blower assembly and slide it into the chassis, pushing firmly to ensure that it is seated. 2. Verify that the power LED displays a green light. 3. Use the screwdriver or your fingers to tighten the captive screws.
Blower Assembly Replacement Procedure 53-1001804-01
