53-1001795-01 January 31, 2010 PowerConnect B-DCX-4S Vertical Cable Management Fingers Replacement Procedure Supporting PowerConnect B-DCX-4S Backbone 53-1001795-01 *53-1001795-01*
Notes, Cautions, and Warnings NOTE A NOTE indicates important information that helps you make better use of your computer. CAUTION See the safety and regulatory information that shipped with your system. For additional regulatory information, see the Regulatory Compliance Homepage on www.dell.com at the following location: www.dell.com/regulatory_compliance. CAUTION A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed.
In this guide • Installing the PowerConnect B-DCX-4S Vertical Cable Management Fingers • Time required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . • Items required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . • Removing the cable management finger assembly. . . . . . . . . . . . . . . . . . . . • Replacing the cables management finger assemblies . . . . . . . . . . . . . . . . .
FIGURE 1 Vertical cable management finger assemblies Replacing the cables management finger assemblies 1. Position and tighten the three (3) screws to secure the vertical cable management finger assembly to the rack upright. 2. Arrange the cables along the cable management finger assembly. 3. If necessary, repeat step 1 and step 2 for the other cable management assembly.