Activity Meter 2 Tester Quick manual 1 (7)
Table of Contents Federal Communications Commission (FCC) Statement ......................................................................... 2 Technical data ......................................................................................................................................... 3 Reading meter serial number .................................................................................................................. 4 Batteries ..........................................................
Technical data Nominal voltage Battery type Dimensions Weight Ideal environment Operating temperature* Recommended storage temperature* 3 (7) 3V DC AA, 2 pcs 185 x 83 x 33 mm 48 g excluding batteries 119 g including batteries Indoor -20 °C to +55 °C +10 °C to +35 °C
Reading meter serial number DeLaval Activity Meter 2 Tester allows You to read out the serial number from an Activity Meter 2 unit. To read the number from the unit, place the AM2 in the bracket as shown in Figure 1. Note that the AM2 unit needs to be completely inserted in the bracket as shown in Figure 1. Figure 1 Press the button labeled with Test once. The Tester will begin to search for an AM2 unit and during this time the following text will be displayed as in Figure 2.
Note: The shortest interval between two readings of the same AM2 unit is 5 minutes. The serial number will be displayed during 20 seconds and after that the tester will turn itself off. At any time during this interval, the Test-button can be pushed again to start a test of a new AM2 unit. If no AM2 unit is found, the following message in Figure 4 will be displayed and then the tester will turn itself off.
Replacing batteries In order to replace the batteries, perform the following steps: 1. Remove two Philips screws according to picture. Be aware that there are two rubber bushings attached to the screws. See Figure 7. Figure 7 2. Remove the battery lid and replace the two AA batteries. Note so that the direction of the batteries is according to the sketch inside the battery holder. See Figure 8.
Troubleshooting No.