User's Manual

ManualsBrandsDeeper Network ManualsComputers & AccessoriesLoRaWAN Dongle

Table Of Contents

RoLaWAN Dongle

User Manual

Introduction

Deeper helium dongle is a lorawan hotspot device, which is compatible with

Helium LongFi, which combines the leading wireless LongFi protocol and

helium blockchain technology.

Deeper helium dongle is also compatible with all LongFi devices. The dongle

operates with ultra-low power consumption (5W) and its signal range, can

cover more than 10 miles, and provide connections to thousands of LongFi

end nodes detected within its range.

Network Systems

The hotspot of Deeper helium dongle integrates LongFi packet forwarde and

Helium Miner. The hotspot does not send the received LongFi terminal data

packet to the LongFi Network Server first, but forwards it to Helium Miner, and

then forwards it to the Console (Network Server) via the Miner, and then

pushes it to the application platform via the API interface.

Summary of content (5 pages)

PAGE 1
RoLaWAN Dongle User Manual Introduction Deeper helium dongle is a lorawan hotspot device, which is compatible with Helium LongFi, which combines the leading wireless LongFi protocol and helium blockchain technology. Deeper helium dongle is also compatible with all LongFi devices. The dongle operates with ultra-low power consumption (5W) and its signal range, can cover more than 10 miles, and provide connections to thousands of LongFi end nodes detected within its range.
PAGE 2
Specifications Model HLD01, HLD02, HLD03, HLD04 Lorawan Specifications Frequency 902.3MHz-914.9MHz；923MHz-928MHz Channel Capacity 64channel and 8-channels uplink, 1-channel downlink Work model Half duplex Output Power ≤50mW Platform Configurations CPU Quad-core A53@1.5GHZ RAM 2GB DDR4 Storage 8GB EMMC 5.
PAGE 3
2. Configure network connection 2.1 Equipment assembly Open the package, take out the device, USB cable and antenna, insert the SMA female connector of the antenna feeder into the LongFi antenna port of the device and tighten it. 2.
PAGE 4
2.3 Set up distribution network Open the Helium App in your phone, register to enter, and select “Set up Hotspot”. Then select Deeper helium dongle equipment to enter, you can read the network configuration instructions first, or select “Skip” to operate step by step according to the prompts on the page. Insert the AC plug end of the power adapter into the 220VAC mains socket, and the other end of the DC5V output plug into the power jack of the MINI module, as shown in the figure below.
PAGE 5
should be no violent collisions and drops; ※ The installation location of the product is on a flat wall with less dust and dryness and ventilation, and a location with rain, water seepage, and humidity cannot be selected. FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.