User's Manual

P.4
Function Description
1
W
hen the power is connected, the display screen lits one second and displays "MASSAGE MEISTER". And then the buzzer
and display screen all turn off, and enter the off state.
“ON / OFF” for the key
to open/close. Each machine switching, the screen displays "MASSAGE MEISTER" . The default
boot into work mode "0", operating mode "0" means stop mode. The "TIMER 00: 15", "CYCLE" represents a timing cycle.
"MODE" is shown below the operating mode "0" on the screen.
3
When you press any button, the backlight in the display screen will be lit for 5s, and with a short beep with the buzzer
when you press the button .
4
“AUT
O VIBRATE” is automatic cycle mode switch button. The words "AUTO" is displayed on the screen of the
automatic mode. Each time you press the button, the mode switches from stop mode and automatic cycle mode.
Automatic cycle mode starts working from the mode 1 to 9 cycles. Each mode of operation for one minute. Automatically
switch from 9 to 1 to re-start the working time for 15 minutes, and finally shut down.
5
“MENU” is massage mode menu selection key
. When "MANUAL" is displayed on the screen, you can manually choose
one of the massage modes from 1 to 9. And the working time is also 15 minutes, and finally shut down.
a）When the left side of the display shows "HIGH" with 4 bars, it means the motors are in "Strong" status
b）When the left side of the display shows "LOW" with 3 bars, it means the motors are in "Normal" status
c）When the left side of the display shows "LOW" with 2 bars, it means the motors are in "Weak" status
“INTENSITY” is the motor intensity control key. The intensity is divided into "Strong", "Normal" and “Weak” status.
When the device is turned on, the default status is "Normal" with the left side of the display showing "LOW" with 3 bars. It will
strengthen or weaken when you press the button continuously.
a）W
hen the right side of the display shows "HIGH" with 4 bars, it means the motors are in "Fast" status
“SPEED” is for the motor vibration speed control key. The speed is divided into "Fast", "Normal" and "Slow" stutus.
b）When the right side of the display shows "LOW" with 3 bars, it means the motors are in "Normal" status
c）When the right side of the display shows "LOW" with 2 bars, it means the motors are in "Slow" status
VERSIO
N :
G
CUST
OMER
'
SP
ARTNO :
W
hen the device is turned on, the default status is "Normal" with the right side of the display showing "LOW" with 3 bars. It will
speed up or slow down when you press the button continuously.
00
CUSTOMER'S MODEL NO.:
NIL
CUST
OMER S
PA
RT
NO
.
:
DA
TE :
Controller P-0510-CT User Manual
7
6
2
5