Installation Instructions

FCC ID: 2AIBVTFFBV4

IC ID: 22715-VTFFBV4

◆ 依據低功率電波輻射性電機管理辦法

第十二條

※取得審驗證明之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率

或變更原設計之特性及功能。

第十四條

※低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並

改善至無干擾時方得繼續使用。

-前項合法通信，指依電信法規定作業之無線電通信。

-低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

◆ FCC Compliance Statement:

Any changes or modifications not expressly approved by the party responsible for compliance

could void your authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful interference, and

(2) (2) this device must accept any interference received, including interference that may

cause undesired operation.

RF exposure statements

This Transmitter must not be co‐located or operating in conjunction with any other antenna or

transmitter.

This device complies with FCC radiation exposure limits set forth for an uncontrolled environment.

Ln order to avoid the possibility of exceeding the Fcc radio frequency exposure limits, human

proximity to the antenna shall not be less than 20cm (8inches) during normal operation.

PAGE 1
FCC ID: 2AIBVTFFBV4 IC ID: 22715-VTFFBV4 ◆ 依據低功率電波輻射性電機管理辦法第十二條 ※取得審驗證明之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。第十四條 ※低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。 -前項合法通信，指依電信法規定作業之無線電通信。 -低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。 ◆ FCC Compliance Statement: Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
PAGE 2
◆ Canadian Compliance Statement This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following two conditions: 1) This device may not cause interference, and 2) This device must accept any interference, including interference that may cause undesired operation 3) of the device. 4) Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio 5) exempts de licence.