Installation Guide

Parts List:
No
Photo
A (1PC) B (2PC) C (8 PC) D1 (1PC) D2 (2PC) E1 (2PC) E2 (2PC) E3 (2PC) E4 (2PC) F (2PC)
Model>Modelo:
EC3025
12m
(1).Larger the holes to 12mm
2.
(1)
Measure the distance between two holes on upper back board, then fix
down the place you want to hang the vanity,make note by pencil where
to open the holes .
Use a small drill ( 3mm or smaller) to open the holes to check what is
behind the wall empty space or studs.
If empty space behind the wall,install as step 2.
If studs behind the wall,install as step 3.
1.
(1)
(2)
A
B
C
E4
E3
E2
D1
D2
E1
(3). Put the decoration cap (B4) on B2.
(2).Seperate screw E1,E2,E3,E4, install E3 through the Vanity .
12mm
12mm
(2)
E2
E4
E1
E3
A
A
A
E4
E2
F
F
3.
(3)
Use the screw(F) directly on the studs as shown picture below.