Deako Smart Switch
Get to know your Deako Switch 2
Main button Configure button 3
LED key LED COLOR 4 WHAT IT MEANS Blinking green Powering up Blinking purple Linking mode Blinking blue Pairing mode Blinking white Pairing or Linking
LED COLOR WHAT IT ME ANS Solid white Pairing or Linking successful Blinking red Error occured, try again Solid red Factory resetting 5
How many switches control this light? 6
1 switch 2+ switches If one switch controls this light, CONTINUE TO PAGE 8 If two or more switches control this light, TURN TO PAGE 12 7
Insert switch 1 8 Align the blue tab on the backplate with the top of the switch
2 While pressing the switch inwards, push in the blue tab 9
Installation complete! Now let’s get smart.
Pairing Control your new smart switch by downloading the Deako App.
Remove existing switch 1 12 If there is a switch installed in the backplate you want to upgrade, start by pulling the corner of the faceplate
2 Pull the blue tab outwards to release the switch 13
Insert a smart switch 3 Locate the powered backplate in the circuit by inserting a smart switch into a backplate in the circuit Align the blue tab on the backplate with the top of the switch 14
4 While pressing the switch inwards, push in the blue tab If the backplate is powered, the switch will flash green If switch does not flash green, move to the next location & repeat step 1 15
5 16 Wait until the switch stops flashing green, then press & hold the configure button until it flashes purple
6 Move to the next powered backplate, then repeat steps 1-5 for each switch in the circuit 17
7 Once all switches in the circuit are flashing purple, press & hold the configure button on any switch until it flashes white Once the switches show solid white and turn off, linking is complete 18
8 To test if they’ve been successfully linked, press each switch to confirm that they control the light To pair your linked switches, see page 11 19
Troubleshooting • • • • 20 Linking is only required for 3-way and 4-way wiring configurations If at any point a switch blinks red, factory reset it and try again To exit linking mode at any point, press & hold the configure button for 10 seconds to factory reset each switch before retrying If you have dead-end or other nontraditional wiring in your home, you can find wiring and setup instructions at deako.
Factory reset Press & hold the configure button for 10 seconds (the LED will be appear solid red).
Boring legal stuff NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: 1. L’appareil ne doit pas produire de brouillage; 2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. To maintain compliance with the RF exposure guidelines, place the product at least 20cm from nearby persons.
Need help? support.deako.