ECAM35X.50 BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE Instruction for Use Instructions videos available at: http://ecam35050.delonghi.
A1 A A2 A3 A5 A4 A6 A7 B A8 A9 A21 A10 A20 A19 A11 A12 A16 A13 A14 A17 A15 A18 2
EN page 4 B B1 B3 B2 B5 B4 B6 B7 B8 B9 B10 B11 B12 B13 ESC B14 C OK B15 D C1* C2* D1 D2 C3* C4* D3 C5* D5 D4 C6 3
CONTENTS 1. INTRODUCTION..........................................5 16.9 Cleaning the infuser ....................................14 16.10 Cleaning the milk container ........................15 16.11 Cleaning the hot water nozzle .....................15 1.1 Letters in brackets .........................................5 1.2 Troubleshooting and repairs..........................5 17. DESCALING .............................................. 15 18. SETTING WATER HARDNESS ...................... 17 2.
1. INTRODUCTION 2.2 Thank you for choosing this bean to cup espresso and cappuccino machine. We hope you enjoy using your new appliance. Take a few minutes to read this Instruction for Use. This will avoid all risks and damage to the appliance. (page 2 - B ) A number of icons on the touch screen have a double function. This is indicated in brackets in the description. B1.
D4. Milk intake tube D5. Frothed milk spout (adjustable) 3. SETTING UP THE APPLIANCE Please note: • The first time you use the appliance, rinse with hot water all removable accessories which may come into contact with water or milk. • Possible traces of coffee in the mill are the result of operating tests performed on the appliance before sale, proof of the meticulous care and attention we invest in our products.
low medium high 5. Press the OK icon (B15) to confirm (or ESC (B14) to exit without making any change). The lights go off. The appliance returns to "standby" and the temperature is now programmed. 6 8. AUTO-OFF THE time can be changed so that the appliance switches off after being idle for 15 or 30 minutes, or after 1, 2 or 3 hours. To re-programme Auto-off, proceed as follows: 1. With the machine off (in standby mode) but still plugged into the electrical power supply; 2.
3) To interrupt the function manually, press 5. Press the OK icon (B15) to confirm (or ESC (B14) to exit without making any change). The lights go off. The energy saving setting is now programmed. OK again. Please note: • In energy saving mode, a few seconds may elapse before the first coffee is delivered as the appliance must heat up again.
5. Preparation begins and the indicator corresponding to the selected icon blinks on the touch screen (B). 13.3 Making coffee using coffee beans Important! Do not use green, caramelised or candied coffee beans as they could stick to the coffee mill and make it unusable. Please note: • To make 2 cups of "espresso" at the same time: - Press the icon (B9): the icons corresponding to the beverages available light up, and the icon blinks. Press (B10): preparation begins.
1. Place a sufficiently large cup or glass under the coffee spouts (A19); 2. Press (B8) to select the desired aroma (see section “13.4 Temporarily varying the coffee aroma”); 3. Press and hold the icon corresponding to the coffee to be customized: the icon blinks and all the alarm indicator lights also blink; 4. Release the icon. The icon blinks and the appliance starts delivering coffee; 5. As soon as the coffee in the cup reaches the required level, press the coffee icon again.
14 15 18 4. Place the lid back on the milk container; 5. Remove the hot water spout (C6) from the nozzle (A8) (fig. 15); 6. Attach the container to the connection nozzle and push as far as it will go (fig. 16). The machine emits a beep (if enabled); Dial position Description Recommended for… No froth HOT MILK (not frothed) Min. froth LATTE MACCHIATO Max. froth CAPPUCCINO / HOT MILK (frothed) 14.3 Making milk beverages automatically 1.
3. Release the icon: the icon blinks and the appliance starts delivering the beverage; 4. Once the amount of liquid in the cup is as desired (milk and/or coffee), press the selected icon a second time: the flow will cease. The quantity of the beverage in the cup has now been programmed. 15. DELIVERING HOT WATER Important! Danger of scalding. Never leave the machine unattended when hot water is being released. 1. Make sure the hot water spout (C6) is attached correctly; 2.
Please note: Water may find its way into the grounds container (A11) during the above rinse procedure: this is quite normal. 16.3 Cleaning the coffee grounds container When the indicator light (B2) appears on the touch screen, the container must be emptied and cleaned. The appliance cannot be used to make coffee again until the grounds container (A11) has been cleaned.
16.6 Cleaning the water tank PU SH PU SH 1. Clean the water tank (A17) regularly (about once a month) and whenever the water softener filter (C4) is replaced, using a damp cloth and a little mild washing up liquid; 2. Remove the filter (C4) and rinse under running water; 3. Replace the filter (if installed), fill the tank with fresh water and replace; 4. Release 100 ml of water. 16.7 Cleaning the coffee spouts 1. Clean the coffee spouts (A9) regularly with a sponge or cloth (fig. 24A); 26 25 4.
1. Remove the lid (D2); 2. Remove the milk spout (D5) and intake tube (D4) (fig. 28); 17. DESCALING Important! • Before use, read the instructions and the labelling relative to the descaler product, which are indicated on the pack (included with certain models and/or available for purchase from authorized service centres). • Use De’Longhi descaler only. Using unsuitable descaler and/or performing descaling incorrectly may result in faults not covered by the manufacturer’s guarantee.
10. When the water in the tank has run out, empty the container used to collect the rinsing water; 11. Take out the water tank and fill with fresh water up to the MAX level. 12. If the water softener filter was removed, replace it in its housing in the water tank, and reposition the tank in the appliance; 13. Empty the container used to collect the descaler solution, then position it under the hot water spout. 14. Press OK (B15). 15. Hot water comes out of the hot water spout; 16.
pending on the hardness of the water. Each square corresponds to 1 level; Reagent strip Please note The filter lasts about two months if the appliance is used normally. If the coffee machine is left unused with the filter installed, it will last no longer than 3 weeks. 3. To activate the filter, run tap water through the hole in the filter as shown in fig. 37 until water comes out of the openings at the side for more than a minute; 4. Remove the tank (A17) from the appliance and fill with water; 5.
19.2 Replacing the filter After two months (see date indicator) or when the appliance has not been used for 3 weeks, you should replace the filter: 1. Extract the tank (A17) and exhausted filter (C4); 2. Take the new filter out of its pack and proceed as illustrated in points 2 to 10 of the previous section. The new filter is now activated and the coffee machine can be used. 20. TECHNICAL DATA Voltage: 220-240 V~ 50/60 Hz max. 10A Absorbed power: 1450W Pressure: 1.5MPa (15 bars) Max.
21. EXPLANATION OF LIGHTS LIGHTS DISPLAYED POSSIBLE CAUSE REMEDY The machine is warming up or cooling Wait down. ESC OK BLINKING ESC The coffee maker is ready for use. Proceed with selection of the desired beverage and the relative options. Insufficient water in the tank (A17). Fill the tank and position it correctly, pushing it fully home so that it clicks into place.
LIGHTS DISPLAYED POSSIBLE CAUSE REMEDY The hot water spout is not inserted, or is Attach the water spout securely, pushing fully inserted incorrectly. home. BLINKING The milk container is not inserted Position the milk container securely, pushing correctly. fully home. BLINKING BLINKING The milk container has been inserted Turn the froth adjustment dial to one of the milk with the froth adjustment dial in the froth selection positions. CLEAN position.
INDICATOR LIGHTS DISPLAYED POSSIBLE CAUSE REMEDY The coffee beans have run out PERMANENTLY ALIGHT Fill the beans container (A3) (fig. 9). The pre-ground coffee funnel is clogged Empty the funnel with the help of the brush (C5) (A2). as described in section "16.8 Cleaning the preground coffee funnel". BLINKING The "pre-ground coffee" function has Place pre-ground coffee in the funnel or deselect been selected without placing any pre- the "pre-ground" function (fig. 12).
INDICATOR LIGHTS DISPLAYED POSSIBLE CAUSE REMEDY Descaling has been interrupted. PERMANENTLY ALIGHT The procedure must be completed before the machine can be used. Press the OK icon (B15) to start the procedure. OK BLINKING 22. TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact customer services. PROBLEM POSSIBLE CAUSE REMEDY The appliance does not come on It is not plugged into the mains socket.
PROBLEM POSSIBLE CAUSE REMEDY The coffee is delivered too slowly or a drop at a time. The coffee is ground too finely. Turn the grinding adjustment dial (A5) one click clockwise towards "7" while the coffee mill is in operation (fig. 7). Continue one click at a time until coffee delivery is satisfactory. The effect is only visible after delivering 2 coffees (see section “13.1 Adjusting the coffee mill”).
5713229723_00_0621 De’Longhi Appliances via Seitz, 47 31100 Treviso, Italy www.delonghi.