R1S Wireless Fast Charging Car Charger
1.
Twist-lock Air Vent Clip Screw Knob Ball Joint 3M glue bracket Note: 1.The bottom tray can be adjusted telescopically to adapt to mobile phones of different sizes and avoid clamping the side buttons; 2.There are safety protective silicone pads on the inside of the arms and the base to better protect the phone. 2.
3.Assembly and Installation Steps The wireless car charger holder can be fixed at the air outlet through the air outlet clip, or fixed on the central control table through 3M glue bracket. Attention: Please adjust the air outlet clip properly, and do not use the air outlet clip too tight. Do not adjust it to the smallest thickness, otherwise it might be damaged. Note: It is recommended that the holder can be fixed at the air outlet firstly.
Step 2. Pass the ball joint through the grip nut from the smaller opening side. Step 3. Push the ball joint firmly into the groove on the back of the holder, then tighten clockwise the grip nut. Step 4. Find a suitable place in your automobile outlet, insert the holder. Adjust the angle of the holder to fit the sight line.
Method 2- Using with the 3M glue bracket Step 1. Take out the 3M glue bracket and then press the universal ball head of 3M glue bracket into the nut. Step 2. Confirm that the universal ball joint is installed in place, and tighten the nut clockwise. Step 3. Wipe the position where the holder needs to be placed to ensure that it is clean and flat. Step 4.
4.Switch on Power Supply, Wireless Charging Step 1. Plug the car charger into the car’s cigarette lighter base ( Note: The car charger is not included in the package). Step 2. Plug the charging cable USB connector into the car charger. Insert the charging cable Type-C connector into the charging port of the holder to turn on the power. The holder supports 9V/2A and 12V/1.5A car chargers. The use of 5V/2A, 5V/1A and 5V/0.
5.Instruction of Auto Clamping Arms The wireless car charger holder supports automatic induction recognition. Intelligent sensor allows to pick & place it quickly. Just place your phone , the clamping arms will close. A gentle touch on quick release button, it would open automatically. Attention: 1) Do not place your fingers in the horizontal direction of the clamping arm to avoid getting hurt.
6.FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference. (2)This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
7.Cautions Please keep the device dry. Rain, humidity, and various liquids may contain minerals that can corrode electrical circuits. If the device is wet, please dry it or wipe it clean with a soft cloth as soon as possible. Please use a charger compatible with this device when charging. Do not use any damaged chargers. Please do not charge products that are not compatible with this device. Please do not put the device in a cold place.
10.FAQS 1.Clamp arms not working (1) When the clamps don’t open/close as normal, it is because the hidden pressure switch is stuck. Please activate the hidden switch of the wireless car charger. (2) Low temperature can shorten the battery life, which may cause the clamps do not work properly. Please insert the cable to connect the wireless car charger with QC 3.0 car charger for power supply and turn on the warm window blowing of the car, to rise the inside temperature of your devices. 2.
USER GUIDE en.ddpai.com feedback@ddpai.com DDPAI Technology Co.