User's Manual

F49 Operation Manual

F49 is a high power miniPCI card to be used in outdoor wireless systems. Please follow

the following instruction while using this card. This card is meant to be operated (and

used) by system integrators who are aware of the regulatory requirements in the area it is

being used. The following instructions need to be followed while using the card

1) Before inserting the card in a host PC board, please power down the host PC

board first

2) The antenna port (MMCX connector) should be connected to the appropriate load

or antenna before powering up the host board. Lack of Antenna (or load) while

the F49 is powered up will cause severe damage to the card

3) Please make sure any person handling the card with bare hands follows proper

ESD precautions. Improper handling could cause ESD damage.

4) The card should not be tampered or modified in any way. Tampering or

modification could cause the card to fail standard tests

FCC Warning

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct

the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

FCC Caution

Dbii Networks, 201 OAK AVE, #D, Carlsbad, CA 92008 USA Ph: 760-536-8036

PAGE 1
F49 Operation Manual F49 is a high power miniPCI card to be used in outdoor wireless systems. Please follow the following instruction while using this card. This card is meant to be operated (and used) by system integrators who are aware of the regulatory requirements in the area it is being used.
PAGE 2
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. FCC Radiation Exposure Statement To comply with FCC RF exposure requirements in section 1.1307, a minimum separation distance of 3.9 feet is required between the antenna and all occupational persons, and a minimum separation distance of 8.7 feet is required between the antenna and all public persons.