User's Manual

INSTRUCTION MANUAL

PAIRING AND SENSOR ACTIVATION

Pairing: Consult your Ant + or Bluetooth Smart device’s instructions for pairing. Sensor will

need to be activated directly before pairing process.

Sensor Activation: To verify proper position install as below, spin wheel or turn crank more

than two revolutions. Initial sensor activation will be indicated by the LEDs flashing up to 10

times.

Please Note: The sensor will stay active for at least 20 minutes although the LEDs no longer

flash.

Bluetooth Smart Connection: Install and activate sensor. Turn on your phone’s (or other

compatible device) Bluetooth Smart capability. Open the desired cycling app and follow

instructions for Bluetooth Smart sensor connection.

Please note, Bluetooth Smart devices do not always appear in your phone’s listing, even

when connected.

All apps collect, share, and display speed and cadence information differently.

INSTALLATION

INSTALLATION FOR SPEED SENSOR INSTALLATION FOR CADENCE SENSOR

SPECIFICATION

1 Electrical:

1.1 Supply power: 3.0Vdc (CR2032)

1.2 Battery Life: 1 years

1.3 Communication protocol: ANT+ / Bluetooth Smart

2 Mechanical:

2.1 Water resistance: IPX7

2.2 Dimension: 42mm x 36mm x 16.5mm (main body)

3 Environmental:

3.1 Operating temperature: 0℃

~ +60℃

3.2 Storage temperature: -20℃

~ +70℃

4 Function:

4.1 Range: 0.1km/h ~ 99.9km/h(SPEED), 30rpm ~ 240rpm (CADENCE)

4.2 Indication light: White (SPEED), Green (CADENCE)

4.3 Accuracy: +/-0.1Km/h or 1% whichever is larger

4.4 Transmission range: 3 meter (min.)

4.5 Auto power down: 20 minutes

PAGE 1
INSTRUCTION MANUAL PAIRING AND SENSOR ACTIVATION Pairing: Consult your Ant + or Bluetooth Smart device’s instructions for pairing. Sensor will need to be activated directly before pairing process. Sensor Activation: To verify proper position install as below, spin wheel or turn crank more than two revolutions. Initial sensor activation will be indicated by the LEDs flashing up to 10 times. Please Note: The sensor will stay active for at least 20 minutes although the LEDs no longer flash.
PAGE 2
FCC ID: O4GBKM5AB FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the user’s authority to operate the equipment.
PAGE 3
IC:7666A-BKM5AB IC Statement This device complies with Industry Canada licence‐exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. CAN ICES-3(B)/NMB-3(B) Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.