Datasheet

Single Channel Full Frame 4:2:2 Time Base

Corrector

Make copies of your video without noticeable signal loss or noise. Now you can correct an unstable video source before

you make copies. The TBC-1000 is a digital full frame synchronizer that replaces all sync signals from the source. The

result is clean transfers and clear copies. With a built-in four output distribution amplifier for audio and video, you can

quickly make multiple copies with professional results.

• Re-generates all the sync signals to stabilize the

video

• Frame Synchronization with full frame memory

• Built-in four output distribution amplifier for stereo

audio, composite

and Y/C video

• Wide bandwidth, Y/C in 4.5 MHz, composite in 3.5

MHz

• Low Noise, S/N ratio >50dB

• 8-bit video resolution, 4:2:2 sampling rate

• PAL/NTSC system auto detect

PAGE 1
Single Channel Full Frame 4:2:2 Time Base Corrector Make copies of your video without noticeable signal loss or noise. Now you can correct an unstable video source before you make copies. The TBC-1000 is a digital full frame synchronizer that replaces all sync signals from the source. The result is clean transfers and clear copies. With a built-in four output distribution amplifier for audio and video, you can quickly make multiple copies with professional results.
PAGE 2
Installation Diagram:
PAGE 3
Front and Rear Panel Connection: 1. Power LED, LED will light up when power is on. 2. Stereo Audio, S(Y/C) video, and Composite video input jacks. 3. Stereo Audio and Composite video input jacks. 4. S(Y/C) video output jacks. 5. Power ON/OFF Switch. 6. DC 12V power input jack. Operation: 1. Install the equipment as shown in the installation diagram. 2. Turn the power switch on VCRs and TBC-1000. TBC-1000 power LED will light up. 3. Set all recording VCRs to record mode. 4.
PAGE 4
Specifications: INPUTS 1 S(Y/C) Video & 1 Composite Video Source 1 Stereo Audio Source Y/C in: 4—pin 75 ohm DIN connector Composite Video Out: 75 ohm RCA connector, Level: 1.0 Vp-p Stereo Audio RCA Connector Impedance: 100Kohm OUTPUTS 4 S(Y/C) Video Source & 4 Composite Video Source Y/C out: 4—pin 75 ohm DIN connector Composite Video Out: 75 ohm RCA connector, Level: 1.