User Manual

MF2T-L PRINTER USER'S GUIDE

Agency Approvals

FCC Notice

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation.

This equipment has been certified to comply with the limits for a

Class B computing device, pursuant to FCC Rules. The user

is catuioned that changes and modifications made to the

equipment without the approval of the manufacturer could

void the user's authority to operate this equipment.

This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, it may cause harmful interference to radio

communications. However there is no guarantee that interference

will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of

the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for

help

Operation is subject to the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including

interference that may cause undesired operation of the device.

Applicable Directive

• 89/336/EEC, 73/23/EEC

Applicable Standards

• EN55022 (1998)

• EN55024 (1998)

• EN60950 (1992)

Applicable Standards

• TS001

• AN/NZS3260

LP3.book Page 27 Wednesday, April 12, 2006 4:41 PM