Datalogic Skorpio™ User's Manual www.mobile.datalogic.
Datalogic Mobile S.r.l. Via S. Vitalino 13 40012 - Lippo di Calderara di Reno Bologna - Italy Datalogic Skorpio™ - User's Manual Ed.: 03/2007 ALL RIGHTS RESERVED Datalogic reserves the right to make modifications and improvements without prior notification. Datalogic shall not be liable for technical or editorial errors or omissions contained herein, nor for incidental or consequential damages resulting from the use of this material.
CONTENTS DATALOGIC END USER LICENSE AGREEMENT..................................... v REFERENCES ........................................................................................... vii Conventions .................................................................................................vii Reference Documentation ...........................................................................vii Services and Support...................................................................................
3.6 3.6.1 3.6.2 3.7 3.7.1 3.7.2 3.7.3 3.7.4 3.7.5 3.8 3.8.1 3.8.2 3.8.3 3.8.4 3.9 Data Capture Configuration ........................................................................ 21 Configure .................................................................................................... 21 Capture ....................................................................................................... 25 Control Panel ...................................................................................
DATALOGIC END USER LICENSE AGREEMENT BY DOWNLOADING OR INSTALLING THE SOFTWARE, OR BY USING DATALOGIC EQUIPMENT THAT INCLUDES THIS SOFTWARE, YOU ARE CONSENTING TO BE BOUND BY THIS AGREEMENT. IF YOU DO NOT AGREE TO ALL OF THE TERMS OF THIS AGREEMENT, THEN DO NOT DOWNLOAD, INSTALL, USE THE SOFTWARE NOR DATALOGIC EQUIPMENT.
. Limited Warranty. If Customer obtained the Software directly from Datalogic, then Datalogic warrants that during the Warranty Period (as defined below): (i) the media on which the Software is furnished will be free of defects in materials and workmanship under normal use; and (ii) the Software will substantially conform to its published specifications.
REFERENCES CONVENTIONS This manual uses the following conventions: “User” refers to anyone using a Datalogic Skorpio™ mobile computer. “You” refers to the System Administrator or Technical Support person using this manual to install, configure, operate, maintain or troubleshoot a Datalogic Skorpio™ mobile computer. REFERENCE DOCUMENTATION For further information regarding Datalogic Skorpio™ refer to the SDK Help on-Line.
SAFETY REGULATIONS NOTE Read this manual carefully before performing any type of connection to the Datalogic Skorpio™ mobile computer. The user is responsible for any damages caused by incorrect use of the equipment or by inobservance of the indication supplied in this manual. GENERAL SAFETY RULES − Use only the components supplied by the manufacturer for the specific Datalogic Skorpio™ being used.
LASER SAFETY The laser light is visible to the human eye and is emitted from the window indicated in the figure. Laser output window This product complies with 21 CFR Subchapter J AVOID EXPOSURE LASER LIGHT IS EMITTED FROM THIS APERTURE LASER LIGHT - DO NOT STARE INTO BEAM CLASS 2 LASER PRODUCT MAX. OUTPUT RADIATION 1.
ENGLISH The following information is provided to comply with the rules imposed by international authorities and refers to the correct use of your mobile computer. STANDARD LASER SAFETY REGULATIONS This product conforms to the applicable requirements of both CDRH 21 CFR 1040 and EN 60825-1 at the date of manufacture. For installation, use and maintenance, it is not necessary to open the device.
DEUTSCH Die folgenden Informationen stimmen mit den Sicherheitshinweisen überein, die von internationalen Behörden auferlegt wurden, und sie beziehen sich auf den korrekten Gebrauch vom Terminal. NORM FÜR DIE LASERSICHERHEIT Dies Produkt entspricht am Tag der Herstellung den gültigen EN 60825-1 und CDRH 21 CFR 1040 Normen für die Lasersicherheit. Es ist nicht notwendig, das Gerät wegen Betrieb oder Installations-, und WartungsArbeiten zu öffnen.
ESPAÑOL Las informaciones siguientes son presentadas en conformidad con las disposiciones de las autoridades internacionales y se refieren al uso correcto del terminal. NORMATIVAS ESTÁNDAR PARA LA SEGURIDAD LÁSER Este aparato resulta conforme a las normativas vigentes de seguridad láser a la fecha de producción: CDRH 21 CFR 1040 y EN 60825-1. No es necesario abrir el aparato para la instalación, la utilización o la manutención.
Information for the User ENGLISH Contact the competent authority responsible for the management of radio frequency devices of your country to verify any possible restrictions or licenses required. Refer to the web site http://europa.eu.int/comm/enterprise/rtte/spectr.htm for further information. ITALIANO Contatta l'autorità competente per la gestione degli apparati a radio frequenza del tuo paese, per verificare eventuali restrizioni o licenze.
FCC COMPLIANCE Modifications or changes to this equipment without the expressed written approval of Datalogic could void the authority to use the equipment. This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference which may cause undesired operation. FCC ID U4G0020. All 5XX-XXX Wi-Fi models are not FCC certified.
GENERAL VIEW B D C H A I J E F K G A) B) C) D) Transflective display User programmable LED Speaker Charging status and battery low warning LED E) Scan key F) G) H) I) J) Keyboard Microphone Laser safety label Product label Adjustable elastic strap with stylus holders K) Battery pack M N L L) Data Capture/Laser Output Window M) Mini USB connector N) RS232/USB Communication /Charger pins xv
xvi
INTRODUCTION 1 1.1 1 INTRODUCTION DATALOGIC SKORPIO™ DESCRIPTION Datalogic Skorpio™ is a rugged mobile computer particularly suitable for mobile commerce solutions in the retail environment, both on store shelves and in the stock room. Thanks to one of the best ergonomics ever seen on the market, Datalogic Skorpio™ reduces operator fatigue with no compromise in terms of reliability and robustness, resisting harsh environments, multiple drops, strong shocks and repetitive tumbles.
DATALOGIC SKORPIO™ 1 1.2 AVAILABLE MODELS The brand new Datalogic Skorpio™ is available in different models depending on the options it is equipped with. Options are listed below: • • • communication options: Wi-Fi 802.11b, Wi-Fi 802.11b/g, Bluetooth® capture options: Miniature Laser Modules, Alphanumeric keyboard compute options: O.S. version, microprocessor type/speed, memory size For further details about the Datalogic Skorpio™ models refer to the web site: http://www.mobile.datalogic.com. 1.
INTRODUCTION 1 Rechargeable battery packs are not initially charged. Therefore the first operation to perform is to charge them. See paragraph 4.1. NOTE 1.3.1 Inserting Mini SD card Datalogic Skorpio™ provides the possibility to add a mini storage disk to increase the on-board memory capacity. To access the Mini SD card slot and to insert the card, proceed as follows: 1.
1 DATALOGIC SKORPIO™ 2. Remove the Mini SD card slot’s protective rubber cover. 3. Insert the card with the written part upward (as shown in the figure) and push it in, aided by the stylus, until it clicks into place. To recognize the card simply turn off and turn on the Datalogic Skorpio™. See par. 3.4. To remove the Mini SD card, just push it toward the inside, aided by the stylus, until it clicks; a spring system will return it out.
INTRODUCTION 1.3.2 1 Using the Belt Clip To use the belt clip, proceed as follows: 1. Remove the elastic strap and unscrew the strap pivot. 2. Screw the belt clip pivot on the terminal by using the fixing screw.
1 DATALOGIC SKORPIO™ 3. Insert the terminal in the belt clip by sliding the belt clip pivot into the belt clip until it clicks into place. 4. To release the terminal, press the belt clip unlock button.
INTRODUCTION 1.
DATALOGIC SKORPIO™ 2 2 CONNECTIONS 2.1 CONNECTION TO THE HOST COMPUTER 2.1.1 USB Connection You can use a cable to connect the Datalogic Skorpio™ to a host computer to transfer data. A B C Key: A B Host computer Datalogic Skorpio™ C 94A051016 (Standard Mini USB)USB cable For USB communication using the USB cradle it is necessary to insert the power supply plug into the power jack on the base of the cradle and attach the power supply to a power outlet.
CONNECTIONS 2.1.2 2 RS232 Connection The single or multiple RS232 cradle can be connected to the Host by cable 94A054000 for 9-pin connections. The RJ45 connector of the desired cable must be connected to the RS232 port of the cradle. Then, it is necessary to insert the power supply plug into the power jack on the base of the cradle and attach the power supply to a power outlet. Once the Host has been turned on, insert the Datalogic Skorpio™ terminal into the cradle.
DATALOGIC SKORPIO™ 2 2.1.3 Modem Connection The Datalogic Skorpio™ Serial/Modem Cradle has an integrated modem and provides a modem connector, which can be used with an RJ11 connector. It can be connected to a telephone line to transfer data to a Host. B A C Key: A) Phone line to remote Host B) Datalogic Skorpio™ Serial / Modem Cradle C) Power Supply* * Recommended Power Supply: FPS18 AC/DC Power Supply (94ACC4595).
CONNECTIONS 2.1.5 2 WLAN Connection Datalogic Skorpio™ Wi-Fi models can communicate with the host using the on-board radio frequency module and an Access Point connected to the host computer. A B C Key: A) Datalogic Skorpio™ B) Access point C) Host – Application Server NOTE In order to avoid wasting power, the Wi-Fi module is off by default. If you need to have the Wi-Fi module working, the module must be powered on using the Wireless Communications applet (see par. 3.7.4).
DATALOGIC SKORPIO™ 2 2.1.6 WPAN Connections Datalogic Skorpio™ Bluetooth® models can communicate with a Bluetooth® device, ® such as a printer, within a range of 10 m, using the on-board Bluetooth module. A B Key: A) Datalogic Skorpio™ ® B) Bluetooth printer NOTE 12 In order to avoid wasting power, the Bluetooth® module is off by default. If you need to have Bluetooth® working, the module must be powered on using the Wireless Communications applet (see par. 3.7.
USE AND FUNCTIONING 3 3 USE AND FUNCTIONING The use of the Datalogic Skorpio™ depends on the application software loaded. However there are several parameters that can be set and utilities that can be used to perform some basic functions such as data capture, communications, file management, etc. 3.1 STARTUP The Datalogic Skorpio™ turns on when the battery pack or the external supply is inserted. After the battery pack is installed, use the [ON/OFF] key to turn the mobile computer on and off.
DATALOGIC SKORPIO™ 3 The mobile computer goes into power-off (low power with display backlight off), when it is no longer used for more than a programmable timeout, which is defined in the POWER applet of the Control Panel. In this mode it can be awakened (resuming operation) by the [ON/OFF] key or SCAN key if enabled (see par. 3.7.1). The mobile computer can also be awakened or turned off by the application program. NOTE 3.2 USING THE STYLUS The stylus selects items and enters information.
USE AND FUNCTIONING 3.3 3 DATA CAPTURE To configure and enable data capture parameters refer to par. 3.6. 3.3.1 Laser Data Capture To scan barcodes, point the Datalogic Skorpio™ laser model onto the code from a distance within the reading range while pressing the SCAN key. The lighted band emitted by the laser must completely intercept the barcode as shown in the figure below. If enabled, the emission of an acoustic signal will indicate that the scan has taken place correctly.
DATALOGIC SKORPIO™ 3 3.4 DESCRIPTION OF THE KEYS The Datalogic Skorpio™ provides a 38-key alphanumeric keyboard. The following image shows this keyboard.
USE AND FUNCTIONING 3 Main Keys Function KEY FUNCTION It starts data capture. If enabled, it also wakes up the mobile computer from low-power (see par. 3.7.1). They let you move forwards, backwards, upwards or downwards within text fields, scroll through a Menu list or browse among folder files. After a blue modifier key press, the blue arrows allow moving forwards or backwards within the Internet Explorer browser pages.
DATALOGIC SKORPIO™ 3 Special Function Icons ICON FUNCTION After a blue modifier key press, it opens the Start menu. After a blue modifier key press, it opens the file manager. After a blue modifier key press, it modifies the display backlight intensity (5 levels available through subsequent presses). After a blue modifier key press, it locks and unlocks the keyboard. Hardware and Software Reset By pressing these keys simultaneously, a system hardware reset is performed.
USE AND FUNCTIONING 3.5 3.5.1 3 STATUS INDICATORS LED Status The Datalogic Skorpio™ provides two different LEDs signaling the mobile computer status. LED STATUS Good Read and General Purpose (left-side) Green It is constant for a configurable time to signal that a successful read has occurred. Green/Red It is also available to the application program. Charging Status and Green constant Battery Low Warning It is constant once the charging process has been completed.
DATALOGIC SKORPIO™ 3 3.5.2 Taskbar The Taskbar provides information about the time, the battery level, the keyboard function, the decoding status and the communication with the host. ICONS DESCRIPTION Time and Battery Icons It displays the time. They are representative of five different icons indicating the battery level. The icon is partially green when the power left is >20% and partially red colored when the power left is <20%.