Rfid Engine R3 Integration Guide R3Integration Guide.doc Revision: 1.
Rfid Engine R3 Test Introduction .................................................................................................................................................................... 3 Block Diagram ................................................................................................................................................................ 3 Comunication Interfaces ..............................................................................................................
Rfid Engine R3 Test Introduction The RF-3 RFID Engine is a dual technology module combining an undecoded laser scan engine with a multi-standard high frequency RFID engine (requiring an ANSI C library for decoding). Thus, it provides a single product allowing reading standard barcode symbologies and 13.56 MHz tags and smart labels. The Module is physically and electrically compatible with the Motorola SE1200 laser module thus guaranteeing an easy integration within many Hand-Held barcode readers (Host).
Rfid Engine R3 Test Comunication Interfaces The module can be connected to an host trough a 10 wires flex cable. The pins are used in different ways based on the fact the host is using the module to read a barcode or an RFID tag. In both modes the SCAN_EN signal (pin 5) can be forced low to place the module in sleep state (low-power mode) and to switch the interface to Barcode Mode. The module can be switched from barcode mode to RFID mode simply sending a packet on the SPI interface.
Rfid Engine R3 Test Regulatory FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device my not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution Modifications or changes to this equipment without the expressed written approval of Datalogic Scanning Group S.r.l. would void the authority to use the equipment.
