PSC Inc $56 Terry Street Eugene, Oregon 740% Telephone: (541) 683-5700 Fax {561} 345-7340 An Unpublished Ark Alf rights reserved. Ho part of the contents of this documentation or the procedures described therein may be reproduced or transmitted in any form or by any means without prior written permission of PSC Fac.
ing, the Base Station will sound a short beep, followed by twa longer beeps, accompanied by 2 Hashing amber LED. {08h cos Ben mole Bel ppd aie back Face of tis Base Set PL ll Min di Ariadne digger the Base Station. Upon successful link (which ean take 3 few seconds), the image will sound 2 low-to-high pitched beep 11.To verify scanning operation, point the linear ageism ata bar dove and pull the rigger.
Battery Warnings and Cautions £0 not discharge the battery using any device except for the linear image.
Bays Shane he pate A HEE a pens: Bahia ranges Use only the authorized power supplies, battery pack, chargers, and docks supplied by your PSC reseller, The uss CAUTION of any offer power supplies wan damage the linear image and void your warranty, To not disassemble or moodily the battery, The battery cone saint safely and protection devices, which, if damaged, may ase the baloney io general heat, explode or ignite. a not pals the buttery in oF pear fie, 1 Roves or other high temperature locations.
LED and Beeper Indications Some LED and Beeper indications are user-configurable. Those listed in the following ble are standard default settings. See the Product Reference Guide (PRG) for programming information. Condition LED Beeper Gaudy to Operate None How to Scan The figure below shows the right and rang wags w scan a bar code. 1. The linear image must he pointed ata sight angle to the bar code so that the light reflected off the bar dose con be “seen” by the Sin car image.
This device complies with Part 18 of the FCC Rules. Operation is subbed to the following two conditions: {1} This device may nol cause harmful interference, {this device must accept any interference received, including interference that may cause undesired operation, 15.105 Federal Communications Commission (FCO) Requirements, Part 15 This equipment has been tested and found to comply with the Emits for a class B digital device, pursuant to part 15 of the FCC Rules.
(€0984 Is herewith confirmed to comply with the requirements set out in the Council Directive on lhe Approximation of the Laws of the Member States relating lo Alec ferromagnetic Compatibility (89/336/ EEC), Low-voltage Directive (73/23/ EEC) and the Amendment Directive (93/68/EEC), the procedures given in European Council Directive 99/5/EC and 89/3360EEC, The equipment was passed. The test was performed according to the following European standards: EN 300 328 V.1.6.1 (2003-04) EN 301 480-1 V.1.4.