User's Manual

Telemetry Transmitter User Guide Appendix – Compliance Statement
Émetteur de télémesure Guide de l'utilisateur Annexe -
Déclaration de conformité (Projet)
Part Number (Référence) 000380-001 Rev 12
Thank you for purchasing DSI Telemetry Transmitters. DSI is required to provide this guide
because the devices transmit information using radiofrequency waves. It contains details on the
intended use of the transmitters, 1999/5/EC (R&TTE Directive) conformity, FCC compliance,
and proper transmitter disposal. Please read this guide carefully and retain for future reference.
For additional information on the product warranty, exchanges, and use, please visit
www.datasci.com.
Intended Use:
DSI Telemetry Transmitters are intended for measuring physiologic parameters in laboratory animals.
Transmitters range in size to accommodate a wide range of research animals and the transmitter shape
allows for subcutaneous or intraperitoneal placement.
Declaration of Conformity:
These transmitters conform to the requirements of 1999/5/EC (R&TTE Directive). The declaration of
conformity may be viewed on the Internet at www.datasci.com.
Use of 863-869 MHz devices may be subject to licensing in the following countries. For licensing options
please contact the national spectrum management authorities:
Greece Norway Spain Sweden
FCC Statement:
FCC ID _
455 kHz Implant FCCID:MHA02DSI
These devices comply with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and (2) this device must accept any interference that
may cause undesired operation.
This Category II radio communication device complies with Industry Canada Standard RSS-310.
Ce dispositif de radio communication de catégorie II respecte la norme CNR-310 d’Industrie Canada.
FCC ID IC ID _
8 MHz Implant (4ET) FCCID:MHATMS1 IC:5681A-MHATMS1
18 MHz Implant (4ET) FCCID:MHATMS2 IC:5681A-MHATMS2
18 MHz Implant (HD) FCCID:MHAHD18 IC:5681A-MHAHD18
These devices comply with Part 15 of the FCC rules and Industry Canada (IC) RSS 210. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference and (2) this
device must accept any interference that may cause undesired operation.
Ces appareils sont conformes à la partie 15 des règles de la FCC et de l'Industrie du Canada (IC) RSS 210.
Son fonctionnement est soumis aux deux conditions suivantes: (1) Cet appareil ne doit pas causer
d'interférences nuisibles et (2) cet appareil doit accepter toute interférence pouvant causer un
fonctionnement indésirable.