Manualshelf

Installation Manual

ManualsBrandsDATA COMM ManualsAccessories & SuppliesElectronics Commercial Grade Recessed AV/HDMI Cable Conceal Plate with 20 Amp Dual Power Receptacle
123
Use DataComm Electronics’ Recessed Low Voltage Mid-Size Plate with Duplex Surge Suppressor to install low voltage cables behind your flat panel TV,
your amplifier or other audio and video devices. This mid-size plate can be installed upright, sideways.
Features of the 45-0081 Recessed Low Voltage Mid-Size Plate with Duplex Surge Suppressor include:
Compact size fits behind small and large TV’s
TV plug recesses completely into the wall
Duplex receptacle for additional devices
IMPORTANT INSTRUCTIONS:
This product is designed for retrofit work only because the electrical outlet box cannot be attached to a stud.
This product is designed to alert you if you ever lose surge protection. The Surge Suppressor Receptacle is designed to provide protection against short-
term over-voltage conditions as well as from RFI (radio frequency interference). The Surge Suppressor cannot survive, or provide protection in the rare
event of a direct lightning strike on the service power line.
The Surge Suppressor alerts you to the failure of the surge protection component by means of
an audible signal. If alarm sounds, device has “received” power surges in excess of its capacity and is no longer functioning as a surge protector. To shut
off alarm, simply turn the “Alarm Off” screw on the front of the receptacle clockwise. Note: When alarm sounds and the “Alarm Off” screw is turn off, the
receptacle still functions as a normal duplex receptacle without surge protection.
WARNING:
Before you run your 12/2 or 14/2 w/ground UL approved building wire to the Recessed Low Voltage Mid-Size Plate with Duplex Surge
Suppressor, be sure the power is off by switching the circuit breaker to off or removing the fuse(s). Test the power to make sure the power is
off. Be sure to install the Mid-Size Plate with Duplex Surge Suppressor in accordance with the National Electrical Code (NEC) and local codes.
Installation Instructions:
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommelectronics.com
Instruction / Installation Sheet
DataComm Electronics 45-0081 Recessed Low Voltage Mid-Size Plate with Duplex Surge Suppressor
Parts Included:
1. 45-0081 Recessed Low Voltage Mid-Size Plate
2. Electrical Outlet Box
3. 15 Amp/125 Volt Duplex Surge Suppressor
4. Four (4) Screws
Tools Needed:
1. Drywall Saw
2. 6 Ft. Tape Measure
3. Pencil
4. Screwdriver
Figure 1 – Front View
Figure 2 – Back View
Fig. 1
Fig. 2
Figure 1
Top view - shows needed space between the drywall and the studs.
Receptacle side of the Mid-Size Plate should be 3” from the stud but no
more than 5” (review picture carefully).
Figure 2
Using the template supplied (see page 3 of instruction sheet), trace the opening needed. Using a drywall saw,
cut a hole in the drywall the size of the template. See Figure 1 before tracing your opening. Remember, the
plates are designed to be mounted between the studs.
Page 1 of 3 10/1/12
Concealed Wiring
(hidden in wall)
Flat Screen TV
Concealed Wiring
(hidden in wall)
Flat Screen TV

Summary of content (3 pages)