User's Manual

ManualsBrandsDASAN ELECTRON ManualsElectronicsPART15 SPREAD SPECTRUM TRANSMITTER

- 2 -

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions ;

(1) this device may not cause harmful Interference, and (2) this device must

accept any interference received, Including interference that may cause

undesired operation.

Dasan Electron Co.,Ltd.

Product: Bluetooth Headset

Model No : DA-581BT

FCC ID : WF2DA-581BT

Bluetooth Headset

Owner’s Manual

DA-581BT

- 3 -

• CAUTION

The manufacturer is not responsible for any radio or TV interference caused by

unauthorized modifications to this equipment. Such modifications could void the

user’s authority to operate the equipment.

• INFORMATION

This device and its antenna(s) must not be co-located or operating in conjunction with

any other antenna or transmitter except in accordance with FCC multi-transmitter

product procedures.

The use of a permanently attached antenna or of an antenna that user a unique

coupling to the intentional radiator shall be considered sufficient to comply with the

provisions of required this section.

The manufacturer may design the unit so that broken antenna can be replaced by the

user, but the use of a standard antenna jack or electrical connector is prohibited.

※ STATEMENT

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, users, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocated the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/ TV technician for help.

Summary of content (7 pages)

PAGE 1
• CAUTION The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the Bluetooth Headset Owner’s Manual DA-581BT user’s authority to operate the equipment. • INFORMATION This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.
PAGE 2
Introduction Overview The unit is a wireless comfort Bluetooth® headset for mobile phones and offices. Charging LED and LED indicators When mobile phones replace the ordinary phones at the office, you need a comfortable and ergonomic solution for those who spend long hours on the phone. The unit such a solution, a truly comfortable headset with good sound quality, built for comfortable all day wearing.
PAGE 3
Headband adjustment On Cradle charging From wall adapter Adjust the headband to a comfortable fit by sliding the headband up or down. If the headset has been out of use for some item, it may take up to five hours to charge it fully. Normal charging time is 3-4 hours. Low battery is indicated by the flashing red LED on the headset. The LED’s on the charging stand indicates charging status. The headset can only be placed in one direction in the charging stand.
PAGE 4
General procedure z Turn on Bluetooth on your phone Volume adjustment z Put the headset in pairing mode (make sure the headset is switched off, press z Press volume up/volume down to adjust the listening volume. There is a small notch on each volume button that makes them easy to find. The headset listening volume can also be adjusted on the phone. and hold the answer button for 4-5 seconds until the LED flashes red and green) z Perform a search for Bluetooth devices on your phone.
PAGE 5
z simultaneously briefly. A beep tone is heard in the speaker. parts, and must not be opened. Mute A Bluetooth device use radio signals to communicate with other devices. The power z of this radio signal is low, maximum 0.001 Watts. Do not use the product where it is Press and release the mute button. Press again to resume the call. forbidden, for example in air planes, at hospitals, in blasting areas or in explosive A beep tone is heard every thirty seconds when mute mode is active. atmospheres.
PAGE 6
Help and tips Troubleshooting z Do not expose the headset to moist, liquids, rain or dust. z Store the product at a dry and dust-free location. z For cleaning, use a dry cloth. z Do not store a fully charged headset in the charging stand for longer periods of If you have problems connecting the headset to your phone, do as follows: z Check that the headset is charged, turned on and within 10 meters of the phone. z Check that Bluetooth is switched on your phone.
PAGE 7
Equipment Specification Equipment Name Bluetooth Headset Model No DA-581BT Brand Name None Usage Wireless Hands-free for Cellular phone Serial Number Prototype ITU emission Code 1M00F1D Oscillation Type PLL (Phase Local Loop) Modulation Type FHSS (Frequency Hopping Spread Spectrum), GFSK Emission Type F1D Maximum Power 4.71㎽ (6.